34
Bracket Installation
Mount the unit in any convenient location, provided there is clearance
when it’s tilted for the best viewing angle.
You should also make sure
there is enough room behind the unit to attach the power
transduce
cable. (See the following drawings, which show the dimensions of a
mounted Cuda 350 sonar unit.)
Holes in the bracket’s base allow wood screw or through-bolt mounting.
ou may need to place a piece of plywood on the back side of thin pan-
els to reinforce the panel and secure the mounting hardware.
Drill a 5/8" (15.9 mm) hole in the dash for the power/transducer cable.
The best location for this hole is immediately under the mountin
bracket location. This way, the bracket can be installed so that it covers
the hole, holds the cable in position and results in a neat installation.
Some customers, however, prefer
to mount the bracket to the side o
the cable hole — it's a matter of personal preference. After drilling the
hole, pass the connector up through the hole from under the dash.
www.busse-yachtshop.de | info@busse-yachtshop.de
