Handleiding EK63-EdilKamin Spot 100H (pagina 13 van 32) (Engels)

810943

Verklein

Vergroot

Pagina terug

1/32

Pagina verder

INSTALLATION

THE FLUE

Further to the general prescriptions for the fumes

duct and ﬂ ue, the ﬂ ue

• must serve solely to exhaust fumes

• must be correctly sized to satisfy the requirements

of fumes exhaust (EN 13384-1)

• should preferably be insulated, in steel with

a circular internal section. If rectangular, the

corners must have a radius of not less than 20

mm, with a ratio of the internal dimensions of

<1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• must preferable have a collection chamber for

uncombusted matter and condensation

• if pre-existing, must be clean, to prevent the ﬁ re

hazard

• in general, we recommend ﬁ tting a tube inside

the existing masonry chimney if its diameter is

greater than 150 mm.

INTUBATED SYSTEM

Further to the general prescriptions for the fumes

duct and ﬂ ue, the intubated system:

• must operate in negative pressure;

• must be open to inspection;

• must observe local regulations.

THE CHIMNEY POT

• must be windproof

• must have an internal cross section equivalent to

that of the ﬂ ue and a fumes outlet at least double

that of the interior of the ﬂ ue

• for dual ﬂ ues (which should be spaced at least

2 m apart) the chimney pot receiving the fumes

from the solid fuel appliance or that from the

higher storey, must be at least 50 cm higher than

the other

• it must extend beyond the back ﬂ ow zone (in

Italy, refer to UNI 10683 point 6.5.8.)

• it must allow for maintenance of the chimney.

COMBUSTION AIR INTAKE

In general, we suggest two ways to ensure a proper

ﬂ ow of combustion air. The air must be drawn from

outside*

Please remember to also ensure air exchange for

heating and glass cleaning air, etc.

Indirect air intake

The boiler stove draws the air from outside through a

hole at the rear.

Install an air outlet at ﬂ oor level with an eﬀ ective

surface area (net of the screen or other protections)

of at least 80 cm2 (10 cm in diameter).

To prevent draughts, we recommend installing the

intake behind the product or behind a radiator.

Installing it in front of the appliance will create

unpleasant draughts.

Direct air intake **

Install an air intake of eﬀ ective surface area (net of

the mesh or other protective equipment) equal to

the cross section of the air intake at the back of the

product.

Connect the air intake to the appliance’s air intake

with a tube (which may also be ﬂ exible). Increase the

diameter of the pipe if the pipe is not smooth: assess

any load loss.

We recommend not exceeding a 3 m length, keeping

in mind the draw of the ﬂ ue. For each curve, up to

a maximum of two curves, the length should be

reduced by 1 m. Assess whether or not to increase

the diameter of the pipe.

* The air maybe drawn from an adjacent room only if:

• the ﬂ ow is taken from permanent and unobstructed

openings communicating with the outdoors;

• the air pressure in the adjacent room is never

lower than that of the outdoor pressure;

• the adjacent room is not a garage. subject to ﬁ re

hazard, a bathroom or bedroom;

• the adjacent room is not a shared room in the

condominium.

In Italy, UNI 10683 provides that ventilation is

suﬃ cient even if a pressure diﬀ erence between

the outdoors and indoors of no more than 4 PA is

guaranteed (UNI EN 13384-1). The installer who

issues the declaration of conformity is responsible for

ensuring these conditions.

** Direct connection to the air intake will not make

the product airtight. It is therefore necessary to

additionally ensure an air intake from within the room

where the product is installed (i.e. for glass cleaning).

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

EK63-EdilKamin Spot 100H Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van EK63-EdilKamin Spot 100H

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info