11 Information messages
11.1 Needle not in basic position
If the needle is not in its basic upper position at the sewing start, this
information code will appear.
Erro r Co rre c t i on
–
Tur n the handwheel until the information disappears.
11.2 Threading mode
As long as the sewing automat is in the “Threading mode”, the
information code in the margin appears.
Erro r Co rre c t i on
–
Press the button at the head cover.
11.3 Thread breakage
Should the thread breaks during the sewing operation, the information
code in the margin appears in the display.
Correction
–
Press the button a t the head cover to get into the “threading mode”.
–
Thread in the sewing automat.
–
Press the button at the head cover again to exit the “threading
mode”.
11.4 Gimp not inserted
Hint:
Appears only with the subclasses 141 or 341 and with the gimp
monitoring mounted and activated.
The sewing process can be continued by pressing the OK-key or the
push button 2 or interrupted by pressing the ESC-key or the push
button 1.
11.5 Pressure monitor
The pressure monitor monitors the air pressure of the air supply. When
there is no compressed air or the pressure is too little this information
code will appear on the display.
Erro r co rre c t i on
–
Switch off the sewing automat.
–
Supply sufficient compressed air.
–
Switch the sewing automat on again.
45
