801276
25
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
Instructions for use ST4D 2G / ST4D 2G PLUS
25
Drive Medical GmbH & Co. KG | As per: 04.05.2020 | Errors and alterations excepted
EN
Transport
Use a ramp to load the scooter. If necessary, you can
also lift the scooter over a step or the like. At least two
people are needed to do this. Lift the scooter only at
fixed parts of the frame, in the front and rear under the
cladding. For safety reasons, the scooter may be lifted
only WITHOUT the user.
Do NOT remain seated in your scooter when the scooter
is being transported in a vehicle. Always secure your
scooter and use a seat in the vehicle.
Exception: Taking your scooter with you in public trans-
port buses.
Storage
Ensure that the electric scooter is switched o and
stored with the battery removed and the charging unit
unplugged. Store the electric scooter in areas protected
from direct sunlight, water, and humidity.
Cleaning | Disinfection
Clean regularly with a moist cloth!
Do not use any aggressive cleaning agents!
Do not use abrasive cleaners!
Do not use any high-dose chlorine and vinegar-based
cleaners!
To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
Check the screws regularly and tighten, if necessary.
The product must not be continuously exposed to
temperatures over 60°C.
In the event of defects, contact your specialist dealer
from whom you purchased this product.
Do not use any petroleum ether, solutions or evapo-
rating solutions since these could damage body parts.
Ensure that the charging unit was removed and that
the electric scooter is switched o before you clean it.
Do not park your electric scooter under wet or damp
conditions since this leads to mold growth and a rapid
deterioration of the cushioned parts.
Problem Cause Remedy
Electric scooter cannot
be switched on Batteries not connected
Circuit breaker/overload switch was triggered
Check battery connection
Press circuit breaker to reset
Electric scooter can be
switched on but does
not drive
Defective batteries
Charging unit is inserted
Motor is in neutral
Charge/replace battery
Remove charging unit from the electric
scooter
Put neutral lever into “Drive”
Electric scooter drives
slowly Weak batteries
Speed is set to low
Charge battery
Select higher speed
The seat moves during
operation The seat is not properly snapped into place Rotate the seat slowly until it snaps
into place and is secured (see section
entitled "Seat”).
The steering column
appears to be loose or
does not freely swivel
The fixing screws for the steering column are
loose
Tighten the fixing screws for the steering
column
Horn sounds
unintentionally or
automatically
The electric scooter has diagnosed an error Ensure that the control lever is not
operated and switch the electric scooter
o and on.
Charge the batteries if the problem
persists.
Troubleshooting
25

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Drive ST4D 2G PLUS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Drive ST4D 2G PLUS in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans als bijlage per email.

De handleiding is 6.77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info