775776
49
Verklein
Vergroot
Pagina terug
1/116
Pagina verder
49
DO987BFK
www.domo-elektro.be
EN
· Avoid direct sunlight and heat. Direct sunlight may aect the acrylic
coating. Heat sources nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to
from very quickly on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the
voltage stated on the rating label of your appliance corresponds to the
voltage in your home. A dierent voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible
for damages that may occur as a result of usage without grounding.
· After installation, leave the freezer for 8 hours before turning it on. This
way the refrigerant can settle.
· Allow the appliance to run empty for 24 hours so the compartment can
cool to the appropriate temperature.
· This appliance is designed to operate in ambient temperature between
16°C and 38°C. If these temperatures are exceeded, i.e. colder or
warmer, the appliance will not operate correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty.
After reversing the door, leave the appliance alone for 8 hours before switching it on. This allows the
coolant to set. We recommend using a slotted screwdriver, a Phillips screwdriver, and a wrench (not
included), as well as the components supplied below.
Hinge cover plate
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
Top door stopper
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
Bottom door stopper
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
1. Loosen the screws of the hinge cover plate and remove the plate. Disconnect both connectors of the
cables.
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
13
y
y
,QVWDOODWLRQ
1007NN
1071NN
6SDFH5HTXLUHPHQW
Keep enough space of door open.
Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
/HYHOOLQJWKHXQLW
13
49

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Domo DO987BFK bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Domo DO987BFK in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 19.26 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info