517884
9
Verklein
Vergroot
Pagina terug
1/71
Pagina verder
7
5.3.1 OIL CHANGE
Use detergent oil for fourstroke engines, class API SG or SF
(indicated on the oil can) with SAE viscosity suitable for the
climate (see table).
To allow the oil to drain out easier, run the engine for about
3÷5 minutes. Then discharge the oil when the engine is still
warm so that the emptying is quicker and more complete via
the drainage hose (pos. 2 fig. 8 and 15) by removing the
drain cap (pos. 8 fig. 8 and 15).
Top up with oil of the recommended type via the filling cap
(pos. 9 fig. 8).
Table 2 shows the amount of oil in the oil pan.
Mod. Liters
2500 0.6
4000 1.1
5500 1.1
TA
B. 2
DANGER
Warm oil may burn you.
Running the engine with a poor amount of oil can
seriously damage the engine itself.
Check the oil level when engine is stopped.
IMPORTANT
Used oils must never be poured on the ground. They shall
be collected and consigned to qualified companies for the
disposal in accordance with any local regulations.
5.3.2 AIR FILTER MAINTENANCE
IMPORTANT
A dirty air filter reduces the air flow to the carburettor. To
keep the carburettor working properly, check it often. Check
more frequently if the engine is used in dusty areas.
DANGER
Never use diesel oil or solvents with a low evaporation point
for cleaning the air filter, since this may lead to danger of
flames or explosion.
Never let the engine run without the air filter. It would get
damaged in a short space of time.
1. Carefully check both cartridges. Replace them if there
are holes or tears
2. Sponge cartridge: wash it with a neutral detergent
so
lution and rinse carefully. Let the cartridge dry
completely, then soak it in clean engine oil and wring out
the excess.
3. Paper cartridge: smoothly beat it several times on a hard
surface to remove any dirt, or blow compressed air
through the filter from inside to out. Do not brush the dirt:
this operation would just push it into the fibres. If the
paper cartridge is too dirty, replace it.
5.3.3 SPARK PLUG MAINTENANCE
RECOMMENDED SPARK PLUG:
Mod. 2500/4000/5500
BP6ES, BPR6ES NGK
W20EPU, W20EPRU ND
Never use a spark plug with a different thermal degree.
1. Remove the spark plug nipple (pos. 1 fig. 8) and use a
suitable wrench to remove the spark plug.
2. Visually check the spark plug. If it is worn or if the
insulator is broken or chipped, replace it. Clean the
spark plug with an iron brush if it is to be used again.
3. Measure the electrode distance by means of a thickness
gauge.
The distance should be 0.70.8 mm.
Adjust, if necessary, by bending the side electrode.
4. Check that the spark plug washer is in good condition
and screw it manually to prevent it being set at an angle.
5. Once mounted, tighten the spark plug using a wrench
with the right driving torque.
-30° -20° -10 ° 0 10 ° 20° 30° 40°
Room Temperature
MULTIGRADE
SG / SF
Hot climates
Cold climates
10W 30
15W 50
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dometic T4000H bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dometic T4000H in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 2,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info