652866
8
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
8
4.0.1
4.0.2
4.0.3
4.1.1
4.2.1
4.2.2
4.2.3
4.2.4
4.3.1
4.3.2
4.3.3
4.3.4
4.3.5
Do not immerse the snore stopper in water or other liquids.
A suitable, commercially available disinfectant may be used for disinfecting the
device. Let the snore stopper dry completely afterwards.
For hygienic reasons, every user should use his/her own adhesive electrodes.
Gently clean the surfaces of the snore stopper with a soft, damp cloth. Use water
to wet the cloth. Use a mild detergent in case of stubborn stains. Ensure that the
snore stopper has been switched off. Therefore, you must always remove the
batteries before cleaning the device. Let the snore stopper dry completely
afterwards. Do not use chemical detergents or abrasive cleaners to clean the
snore stopper or the adhesive electrodes.
The snore stopper must not be exposed to direct sunlight. Do not place the snore
stopper on hot surfaces.
4.3 Cleaning and care of the snore stopper
If the snore stopper ASG 341 is intended for trade or commercial use, a technical
safety inspection is necessary every 2 years in accordance with § 6 MPBetreibV
[German Medical Devices Operator Ordinance]. The technical safety inspection
must be carried out by a company specialised in medical devices. Further
information may be obtained from our service centre (see page 20).
If the device is not used for a prolonged period, remove the batteries from the
device.
Do not dismantle or repair the snore stopper; otherwise, technical or physical
accidents may occur – warning/mortal danger!
The snore stopper is maintenance-free.
4.2 Storage/maintenance of the snore stopper
The adhesive electrodes must not be attached to other parts of the body except
the outside of the respective wrist.
4.1 Where the adhesive electrodes must not be attached
The size of the adhesive electrodes must not be changed, e.g. by cutting off
pieces of the electrodes.
Do not use adhesive electrodes with an electrode size smaller than 20 x 25 mm
(4.8 cm²), as this could lead to the flowing of a too large current density, thereby
possibly causing injuries.
The adhesive electrodes are attached to the inside of the device. Place the snore
stopper against the outside of the wrist. This ensures that the adhesive electrodes
are also pressed against the skin surface on the outside of the wrist. Adjust the
wristband in order that the snore stopper is pressed against the wrist.
4.0 Where the adhesive electrodes must be attached
SAFETY INSTRUCTIONS
3.9.0 Avoid contact between the two electrodes. This will cause a short circuit, during
which an increased current density flows. This increased current density may lead
to burns and injuries.
GB
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dittmann ASG 341 - Snore Stopper bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dittmann ASG 341 - Snore Stopper in de taal/talen: Engels als bijlage per email.

De handleiding is 1,53 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info