Handleiding Dirt Devil M 2012 Lifty PLUS (pagina 15 van 24) (Duits, Engels, Frans)

500169

Verklein

Vergroot

Pagina terug

1/24

Pagina verder

5 Maintenance

5.3 Cleaning the hygienic exhaust filter

1. Switch off the appliance, Zchapter 4.3, „Switching off“

2. Push down the release catch of the exhaust filter cover and fold down

the cover (Fig. 13/A).

3. Pull the hygienic exhaust filter up out of its holder (Fig. 13/B) and tap

the dirt from it over a dust bin.

4. Should this be insufficient, remove the dirt from the filter with a soft

brush, e.g. the furniture brush supplied with the appliance.

5. If such dry cleaning is insufficient, thoroughly rinse the filter by hand in

running clear cold or hand-warm water.

6. If the filter is damaged or deformed, replace it (ordering information

Zchapter 5.4, „Spare parts and accessories“).

7. Place the clean/new exhaust filter back into its fitting (Fig. 14/A).

8. Fit the exhaust filter cover on the rear side first and then push it down

on the front side (Fig. 14/B).

5.4 Spare parts and accessories

 Ordering address: Z see last page

 Further information is available at: Z www.dirtdevil.de

5.5 Recommendation

 We recommend:

Swirl

Y05 dust filter bags with MicroPor

filtration

Swirl



, MicroPor



and "Y05" are registered trade marks of a company of the Melitta group and used with their permission.

5.6 Before you send in the appliance

Before contacting your authorised Royal dealer, Royal service partner or

appliance market or sending in the appliance, first follow the procedure in

the following table to check if you can solve the problem yourself.

ATTENTION:

The filters are washable, but not suitable for cleaning in washing

machines or dishwashers. Do not use chemical cleansers to clean the

filter. Leave the filters to dry after cleaning them with water

(approx. 24 hours at room temperature). Only put them back into the

appliance when they are completely dry.

ATTENTION:

Only use original spare parts from the scope of delivery or those that you

have acquired by reordering.

Item no. Description

7010022 Set of 5 dust filter bags and 1 motor protection filter

7019002 1 hygienic exhaust filter

M203 1 parquet brush

M209 1 turbo brush

NOTE:

Insert the bag in direction "A."

WARNING:

Danger of injury! Never use a defective appliance! Always switch off the

appliance and disconnect it from the mains before starting

troubleshooting Zchapter 4.3, „Switching off“.

Problem Possible cause / solution

The appli-

ance will not

start.

The socket does not carry current.

Test the vacuum cleaner at another socket which you are

sure carries current.

Power cord is damaged.

Have the power cord replaced by Royal Appliance Cus-

tomer Service, address, Z back page.

The dust filter

bag changing

indicator ap-

pears in the

viewing win-

dow.

The dust filter bag is full.

Change the dust filter bag Zchapter 5.1, „Changing the

dust filter bag“.

Nozzle, telescopic tube or suction hose are blocked.

Remove the obstacle. If necessary, use a long wooden

stick (e.g. a broomstick) to do this.

The filter is dirty. Clean the respective filter Zchapter 5.2,

„Cleaning the motor protection filter“ or Zchapter 5.3,

„Cleaning the hygienic exhaust filter“

The vacuum

cleaner stops

suddenly.

The overheating protection has tripped (possibly due to

blocked suction channels, filters, or similar). Switch the

appliance off and pull the plug out of the socket. Remove

the cause of overheating (e.g. by disassembling telescop-

ic tube and suction hose and removing the obstacle and/

or cleaning filters). Wait for about 45 minutes. After the

appliance has cooled off, you may switch it on again.

The cleaning

results are

unsatisfacto-

ry in spite of

the appli-

ance work-

ing correctly.

The bypass vent (Fig. 1/22) is open.Close the bypass

vent (Fig. 1/22).

The attached nozzle is unsuitable. Change the nozzle,

Zchapter 3.2, „Selecting the proper nozzle“

The position of the "carpet/hard floor" selector (Fig. 1/2) is

unsuitable. Set the "carpet/hard floor" selector (Fig. 1/2)

to the correct position for the type of floor, Zchapter 4.2,

„Vacuum cleaning“, step 4.

The dust filter bag is full. Change the dust filter bag

Zchapter 5.1, „Changing the dust filter bag“.

The filter is dirty. Clean the respective filter Zchapter 5.2,

„Cleaning the motor protection filter“ or Zchapter 5.3,

„Cleaning the hygienic exhaust filter“

Nozzle, telescopic tube or suction hose are blocked.

Remove the obstacle. If necessary, use a long wooden

stick (e.g. a broomstick) to do this.

Problem Possible cause / solution

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Dirt Devil M 2012 Lifty PLUS Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info