10
© 2000 Directed Electronics, Inc.
You can also activate Valet Mode using the remote transmitter:
1. Open any vehicle door.
2. Press (or the arm/disarm button).
3. Press (or the channel 2 button).
4. Press again.
The status LED will light solid if you are entering Valet Mode, or
will go out if you are exiting Valet Mode.
Your system has Nuisance Prevention Circuitry to prevent annoying
repetitive trigger sequences due to faulty door pin switches or envi-
ronmental conditions such as thunder, jackhammers, or airport noise.
Here's how it works: Let's say the alarm triggers three times. Each
time, the same sensor or switch is triggering the alarm. The three
triggers are within 60 minutes of each other. NPC will interpret
this pattern of triggers as false alarms. After the third trigger, NPC
ignores, or bypasses, that sensor or switch (along with any other
sensors or switches sharing the same zone).
If the bypassed sensor tries to trigger the system while it is being
bypassed, the 60 minute bypass period will start over. This ensures
that a sensor that continuously triggers will remain bypassed.
Doors are covered by NPC differently: If the alarm is triggered by
an open door for three full cycles (one-and-one-half minutes), the
doors will be bypassed until the trigger ceases.
Nuisance Prevention
®
Circuitry (NPC
®
)
Remote Valet
®
