Handleiding Dimplex OCR1500 (pagina 4 van 24) (Nederlands, Duits, Engels, Frans, Italiaans, Pools, Noors)

798104

Verklein

Vergroot

Pagina terug

1/24

Pagina verder

ELECTRICAL CONNECTION

WARNING THIS APPLIANCE MUST BE EARTHED

Assembly and Positioning

FITTING THE CASTORS

WARNING The radiator must only be operated

with the wheels and castors tted and in the

upright position.

The castors must be tted to the control panel and between the

last and second last n on the opposite end, as shown in Fig.1.

To t the castors, turn the radiator upside down on a carpet or

other soft surface to avoid damage.

WARNING The radiator is heavy – ensure that

it is supported to prevent it from toppling. Ask

a second person to help with this if necessary.

Locate the wire clamp (A) and remove the winged nut (C).

Insert the non threaded end of the wire clamp into one of the

holes in the castor plate (B) as shown. Feed the threaded end

of the wire clamp between the last and second last column ns

ensuring the wire clamp wraps around the column body (sump).

some manipulation of the plate and clamp will be required. The

threaded end should then be passed through the castor plate

and secured using the wing nut.

To t the castor to the control end, position the castor plate in

position and secure using the wing bolts (D). there are guides to

ensure the correct positioning and orientation of the caster plate.

Return the radiator to the correct orientation so it rests on the

castors. The product is now ready for use.

POSITIONING THE HEATER

Select the position for the heater ensuring there is clearance

from any furniture and ttings of at least 300mm above the

heater and 150mm each side and 300mm from the control and

end panel. We recommend maximising the clearance where

possible.

Models & General Information

MODELS

Model Description Power

(W)

OCR1500 7 n, thermostat, three heat settings &

Neon 1500

OCR2000 9 n, thermostat, three heat settings &

Neon 2000

OCR2500 11 n, thermostat, three heat settings &

neon 2500

GENERAL

The radiator is designed for operation on an AC electricity

supply, and is suitable for use in domestic dwellings and similar

indoor locations.

The radiator is tted with castors and a handle for ease of

movement. A rotary selector switch provide the ability to

choose an available heat output and an adjustable thermostat

enables the room temperature to be controlled accordingly. It

is supplied with a cord and plug and is ready for use once the

castors have been correctly tted.

Operation

IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE

PLACED ON THIS HEATER.

Before using the heater ensure that all warnings and instructions

have been read carefully.

Once the castors have been tted, to activate the heater

simply plug it in. Neon indicating lights (i, see Fig 2) located at

the controls area will illuminate when the appliance is plugged

into the mains. This indicates the appliance is energised and

ready for use.

CONTROLS

(See Fig.2 &3)

Thermostat (T)

The Thermostat controls the heat output according to the room

temperature. This ensures that the heater will not produce heat

unnecessarily when the room is warm. To set the temperature

you require, turn the thermostat knob clockwise until the

required setting is reached. Alternatively to heat a cold room

quickly, turn the thermostat knob up fully. When the room

has reached the desired temperature, turn the thermostat

knob anti-clockwise until the thermostat just clicks off. The

heater will now automatically operate at this temperature. The

thermostat also has a frost protection setting marked ‘ ‘.

This setting is useful in areas such as garages, to prevent frost

damage. If the thermostat is set to its minimum setting ‘ ’,

the heater will cycle on and off to maintain a temperature of

approximately 5° to help protect against frost.

Note – Should the heater fail to come on when the thermostat

is at a low setting, this may be due to the room temperature

precise quantity of special oil. Repairs requiring

opening of the oil container are only made by

the manufacturer or his service agents.

When scrapping the appliance, the oil must be

disposed of properly! As this is a category 2 oil, it

must be disposed of only at waste oil collecting

points.

DO NOT use the heater on deep pile carpets or

the long hair type of rugs, or less than 750mm

(30”) away from any overhanging surface. Keep

combustible materials such as drapes and other

furnishings clear from the front, sides and rear of

the heater. Do not use heater to dry your laundry.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Dimplex OCR1500 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info