706576
22
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
17
Installation of the  re (see Figure 1)
1. Remove the wall bracket at the backside of the apparatus by removing the two screws with which the wall bracket is attached.
2. Mount the wall bracket on the wall using the supplied plugs and screws for concrete walls. Make sure that it is spirit level.
3. Hang the apparatus from the mounted wall bracket. Turn the safety mounting bracket at the bottom of the product in such a way that
the mounting hole is visible. Mark the location of this hole and remove the apparatus from the wall. Drill a hole and place a plug in the
wall in the indicated position.
4. Hang the apparatus back on the wall bracket attached to the wall. Secure the apparatus by means of a screw through the safety
mounting bracket.
Make sure that the  re is OFF:
Insert the plug of the  re into a wall socket.
You have to  ll the water reservoir before you use the control knobs (see 'Maintenance', ' Filling the water reservoir').
Manual control
The manual control of the Opti-myst is located at the bottom of the apparatus. (See Figure 2 for a diagram of the manual control.)
Switch 'A': This is the main switch of the  re.
Remark: This switch must be in the 'ON' ( I ) position, because the  re will not work otherwise.
Switch 'B': Push
once to turn on the  ame e ect. The heating will remain o . This is indicated by a single beep. Although the main
lamps will work immediately, it takes another 30 seconds before the  ame e ect starts to function.
Push again to combine the  ame e ect with the heating on 50% of the capacity. This is indicated by two beeps.
Push
again to combine the  ame e ect with the heating on maximum capacity. This is indicated by three beeps.
Push
again to return to only the  ame e ect. This is indicated by a single beep.
Push to set the  re on standby. This is indicated by a single beep.
Control knob 'C': regulates the setting of the thermostat.
Turning the knob towards you lowers the temperature setting. Turning the knob away from you increases the temperature
setting.
Control knob 'D': regulates the intensity of the  ame and the smoke e ect when the  re is turned on.
Turning the control knob towards you reduces the intensity of the  ame and the smoke e ect. Turning the control knob away
from you increases the intensity of the  ame and the smoke e ect.
If the water reservoir is empty, the main lamps will turn o . See the instruction in 'Maintenance', 'Filling the water reservoir'. When this
procedure is completed, the main lamps will turn on, but it takes another 30 seconds before the  ames will turn on again.
Setting the thermostat
Insert the plug in the wall socket and put the  re in the highest heating position. Turn the control knob 'C' completely away from you
(maximum temperature setting) to heat the room quickly. Once the room has reached the desired temperature, you tun the thermostat
knob slowly towards you until you hear a click. This indicates that the thermostat has turned o . The thermostat of the  re ensures that
the room temperature stays at the selected level.
Note: If your  re does not  re up with the thermostat on a low setting, the room temperature might be higher than the thermostat
setting.
Thermal safeguard
A limiting mechanism is built in the fan heater as a thermal safeguard to prevent damage caused by overheating. This can occur if the
heat exhaust is blocked in any way. If the limiting mechanism starts to operate, you must pull the plug of the  re out the wall socket. Wait
approx. 10 minutes before you re-insert the plug. However, prior to turning on the  re, you must remove the obstacles that block the
heat exhaust.
Caution: To prevent  re hazard caused by unintentional setting of the thermal safeguard, the apparatus may not be supplied with
power via an external switch (timer, etc.).
Tips for using the  re
1. If the  ame and smoke setting is in the minimum position, the  re uses approx. 40 ml of water/hour. It will burn three times longer
than with a maximum  ame setting.
2. Do not tilt or move the  re when there is water in the water reservoir or receptacle.
3. Make sure that the stove is attached spirit level to the wall.
4. The ame control knob ‘D’ (Figure 2) can be turned higher or lower for a more realistic e ect.
5. Sometimes the  ames look more natural if the  ame control knob is turned to a low setting.
6. Give the  ame mechanism some time to respond to the changes that you make with the  ame control knob.
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dimplex Nissum Concrete bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dimplex Nissum Concrete in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,94 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info