9.1SCOP (Seasonal coefficient of performance) average climate 35°C / 55°C4.01 / 3.40
9.2ŋs average climate 35°C / 55°C157 / 133
9.3Heat output / coefficient of performance (COP) 810
Heat source / heat sinkEN 14511
Air / waterPerformance level12
with A-15 / W35kW / ---16.9 / 2.631.7 / 2.6
with A-7 / W35kW / ---22.2 / 3.238.0 / 3.0
with A2 / W35kW / ---26.6 / 3.643.4 / 3.4
with A7 / W35-30 kW / ---35.3 / 4.5
with A12 / W35kW / ---38.1 / 4.8
with A7 / W45-40 kW / ---32.9 / 3.7
with A7 / W55-47 kW / ---31.7 / 3.2
9.4Cooling capacity / coefficient of performance (COP) 810
Heat sink / heat sourceEN 14511
Air / waterPerformance level12
with A35 / W23-18kW / ---33.4 / 3.263.3 / 2.8
with A27 / W18kW / ---34.8 / 3.767.8 / 3.5
with A35 / W12-7kW / ---23.1 / 2.548.1 / 2.5
with A27 / W7kW / ---25.2 / 3.051.6 / 3.0
1.For air temperatures between -22°C and 0°C, flow temperature increasing from 45°C to 60°C.
2.The specified maximum heating water flow temperature applies to a set minimum heating water flow.
3.The minimum achievable flow temperature depends on the current volume flow, the set return set temperature and the current performance level.
4.In 2-compressor operation with A35/W7, results in a cooling water temperature difference of 5K ±1K.
5.The heat output and COP is reduced by approx. 5% in lower operation
6.The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation with a flow temperature of 55°C.
The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A)depending on the installation location.
7.Note that additional space is required for pipe connections, operation and maintenance
8.This data indicates the size and capacity of the system. For an analysis of the economic and energy efficiency of the system, the bivalence point and
the regulation should be taken into consideration. These figures are only achieved with clean heat exchangers. Instructions for maintenance, commissioning and operation can
be found in the relevant sections of the assembly and operating instructions. The specified values have the following meaning, e.g. A 7 / W35: heat source temperature 7°C and
heating water flow temperature 35°C.
9.The heat circulating pump and the heat pump manager must always be ready for operation.
10.The values specified apply when using the hydraulic four-way reversing valve (observe instructions for accessories).
Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.
Product:
Spelregels forum
Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:
lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;
Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.
Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.
Abonneren
Abonneer u voor het ontvangen van emails voor uw Dimplex LA60S TUR bij:
nieuwe vragen en antwoorden
nieuwe handleidingen
U ontvangt een email met instructies om u voor één of beide opties in te schrijven.
Ontvang uw handleiding per email
Vul uw emailadres in en ontvang de handleiding van Dimplex LA60S TUR in de taal/talen: Engels als bijlage per email.
De handleiding is 1.53 mb groot.
U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.
Uw handleiding is per email verstuurd. Controleer uw email
Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.
Er is een email naar u verstuurd om uw inschrijving definitief te maken.
Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken
U heeft geen emailadres opgegeven
Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.
Uw vraag is op deze pagina toegevoegd
Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.