4
CONNECTIONS
Refer to the Connection Diagram below.
1. Make certain AC power is off while making connections.
2. Quality cables make a big difference in fidelity and punch.
Use high-quality, audio cables.
3. Do not use excessively long cables. Be sure plugs and jacks
are securely fastened. Loose connections cause hum,
noise, or intermittence that could damage your speakers.
4. Connect all stereo input sources. Then connect any effects
into the stereo Effect, if used. Connect your Microphone(s)
and monitor headphones. Make sure all faders are at
“zero” and the unit is off. Take care to connect only one
cable at a time. pay attention to L and R position of jacks,
on both the DN-X500/DN-X900 and outboard gear.
5. Connect the stereo outputs to the power amplifier(s) and/or
tape deck(s) and/or MD recorder(s) and/or CD recorder(s).
Plug the DN-X500/DN-X900 into AC power outlet.
Tape deck
Turntable 2 Turntable 1
Main unbalanced power amplifier
Main balanced power amplifier
Booth / power amplifier
CD player
Effects processor
CD player
Microphones
Balanced or unbalanced
Microphones
Subwoofer with
Built-in amplifier
NOTE:
Always switch on your audio input sources such as CD players
first, then your mixer, and finally any amplifiers. When turning
off, always reverse this operation by turning off amplifiers,
then your mixer, and then input units.
CD player
1/4” Jack1/4” Jack
1/4” Mono Jack
Lighting system
or Lighting
or 1/4” Jack
DN-X500
3
ENGLISH