12
ENGLISH
10
EXPANDED FUNCTION
Multiple units of the DN-C615 or other DENON products (DN-780R etc.) can be used together for longer play
time, simultaneous recording and other functions.
2 CASCADE (MULTIPULE CONTINUOUS) OPERATION
• Refer to figure 1 to connect the equipment.
• Use a single RCA cable to connect the units’ CASCADE OUT jacks with the units’ CASCADE IN jacks.
• When the first and last units are connected as shown in figure 1, playback is performed endlessly.
• If the first and last units are not connected, operation stops at the last unit.
Cascade playback
1. Set the cascade mode of all unit to the “Cas=ON”. (Preset function)
2. Press the PLAY (1) button y on unit 1. Playback starts.
• Playback on unit 1 ends, playback starts on unit 2.
3. Playback stops when the stop button on the unit currently playing is pressed.
External synchronized recording
The synchronized recording can be use when the DN-C615 is used in combination with DENON other product
(DN-780R etc.).
When the CD player’s play button is pressed, a synchronized signal for starting is output from the EXT. SYNC.
jack. When the STOP buttons on the CD player is pressed, a synchronized signal for stopping is output from the
EXT. SYNC. jack.
• Refer to figure 2 to connect the equipment.
• Use a single RCA cable to connect the units’ EXT. SYNC. OUT jacks with the units’ EXT. SYNC. IN jacks.
✽ Set the infrared remote sensors of all the units to “OFF” when using this function. Also set the same infrared
remote control codes for all the units. (Refer to “PRESET FUNCTIONS AND OPERATIONS” (See page 13).)
Failure to make these settings could result in malfunction.
1. Load the CD into DN-C615. Load unrecorded cassette tapes into all decks.
2. Set the reverse mode and Dolby NR of all decks.
3. Adjust the twin recording level of DN-780Rs. (Master/Slave switch set to OFF.)
4. Press the Twin recording button of DN-780R.
5. Press the PLAY (
1) button y of DN-C615. Recording starts all decks.
6. Press the STOP (
2) button u of the DN-C615 to stop recording on all the connected units.
NOTE:
• Use tapes of the same times (lengths) as far as possible.
