173
RT (Radio Text)
“RT” appears on the display when radio text data is received.
When the RDS button is pressed until “RT” appears on the display
while receiving an RDS broadcast station, the text data broadcast
from the station is displayed. To turn the display off, use the left and
right cursor buttons on the Remote control unit. If no text data is
being broadcast, “NO TEXT DATA” is displayed.
This is the screen when operated.
•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resetting when the power is switched on.
•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the Main unit’s
power switch is off and with the power cord disconnected.
In very rare instances, the AVR-5805 internal microprocessor might lock up, or otherwise cause mis-operation. This might be caused due to an AC
line surge or line spike noise, or by static electric discharge on or nearby the unit, or to connected components. If the condition cannot be corrected
by powering off the unit, including disconnection of the AC cord for a period of ten minutes and subsequent re-connection, then the unit may have
to be re-initialized. Doing so will restore the microprocessor to its original out-of-the-box state, with all custom memories and settings erased, and
the original factory default settings restored. Only use this procedure if you are sure that the microprocessor requires re-initialization.
1Switch off the unit using the Main unit’s power operation
switch.
2Hold the following STANDARD button and HOME THX
CINEMA button, and turn the Main unit’s power operation
switch on.
3Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
•If step 3 does not work, start over from step 1.
•If the microprocessor has been reset, all the settings are reset
to the default values (the values set upon shipment from the
factory).
