CD player
Connecting a CD player
Connect the CD player’s analog output
jacks (ANALOG OUTPUT) to this unit’s CD
jacks using pin plug cords.
Connecting a turntable
Connect the turntable’s output cord to the AVR-5805’s
PHONO jacks, the L (left) plug to the L jack, the R
(right) plug to the right jack.
NOTE:
This unit cannot be used with MC cartridges
directly. Use a separate head amplifier or step-up
transformer.
If humming or other noise is generated when the ground wire is connected,
disconnect the ground wire.
Turntable
(MM cartridge)
Ground wire
AC cord
(Supplied)
Connecting the pre-out jacks
Use these jacks if you wish to connect external power amplifier(s) to increase
the power of the front, center, surround and surround back sound channels,
or for connection to powered loudspeakers.
When using only one surround back speaker, connect it to left channel.
Connecting the AC OUTLETS
AC OUTLETS
•SWITCHED (total capacity – 120 W (1 A.))
The power to these outlets is turned on and off in conjunction with the POWER switch on the main unit, and when the
power is switched between on and standby from the remote control unit.
No power is supplied from these outlets when this unit’s power is at standby. Never connect equipment whose total
capacity is above 120 W (1 A.)
NOTES:
•Only use the AC OUTLETS for audio equipment. Never use them for hair driers, TVs or other electrical appliances.
•The AC outlets can be set to turn on and off for the different functions.
For details, see “Setting the AC Outlet Assign”. (See pages 109, 110)
AC outlets (wall)
AC 120V, 60Hz
MD recorder, CD recorder or other
component equipped with digital
input/output jacks
CD player or other component
equipped with digital output jacks
Connecting the DIGITAL jacks
Use these for connections to audio equipment with
digital output. Only one type of connector needs to
be used, you can decide which based on availability
of coaxial and optical inputs. Refer to pages 58, 59
for instructions on setting this terminal.
NOTES:
•Use 75 Ω/ohms cable pin cords for coaxial connections.
•Use optical cables for optical connections, removing the
cap before connecting.
Connecting a tape deck
Connections for recording:
Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s
tape recording (OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s
tape playback (IN) jacks using pin plug cords.
CD recorder or Tape deck
DENON Link terminal
Use this terminal to connect a DENON DVD player for
high quality digital multichannel sound.
(See page 18)
Route the connection cords, etc., in such a way that
they do not obstruct the ventilation holes.
