97
Advanced Setup – Part 1
Setting the Component In Assign
•This setting assigns the component video input terminal of
the AVR-4806 for the different input sources.
1Press the CURSOR DDor HHbutton to select the
“Component In Assign” at the “Video Setup”
menu, then press the ENTER button.
•Display the “Component In Assign” screen.
2Press the CURSOR DDor HHbutton to select the
input source, then press the CURSOR FFor GG
button to select the component video input
terminal.
Select from among 1-RCA to 3-RCA.
If the same component video input terminal is
selected, the setting for the input source that was
previously assigned switches to “NONE”.
If “Yes” is selected for “Default”, the settings are
reset to the default values.
3Press the ENTER button to enter the setting.
•The “Video Setup” menu reappears.
2Press the CURSOR DDor HHbutton to select the
input source, then press the CURSOR FFor GG
button to select the mode as below.
AUTO:
When there are multiple input signals, the input
signals are detected and the input signal to be
output from the video monitor output terminal is
selected automatically in the following order:
component video, S-Video, composite video.
Component:
The signal connected to the component video
terminal is always played.
The component input signal is down–converted
and output from the composite and S-Video
monitor output terminal.
No image is output from the monitor output
terminal when there is no input signal to the
component input terminal.
S-Video:
The signal connected to the S-Video terminal is
always played.
The S-Video input signal is converted and output
from the composite and component monitor output
terminal.
Setting the Video Convert Mode
•Select the input signal to be output to the composite S-Video
and component monitor output terminals using the video
conversion function.
1Press the CURSOR DDor HHbutton to select the
“Video Convert Mode” at the “Video Setup”
menu, then press the ENTER button.
•Display the “Video Convert Mode” screen.
•If a monitor is connected with an HDMI cable but the
monitor is not compatible with HDMI audio signal playback,
only the video signals are output to the monitor from the
AVR-4806 (DVI mode).
Press the STATUS button to check which mode is set for
outputting HDMI signals from the AVR-4806 (HDMI and DVI
modes).
•Input signals input from the analog and digital terminals are
not output to the TV.
•With HDMI, the video and audio signals are transferred
simultaneously. When HDMI is assigned to an input source,
the digital audio input assignment switches to HDMI along
with the video input.
When this setting is made for input sources to which a digital
audio input (DENON LINK, IEEE1394 etc.) is previously
assigned, the digital audio assignment is set to HDMI.
In this case, reassign the digital input using the procedure
described at “Digital In Assign” ( page 89) and
“IEEE1394 Assign” ( page 92).
The details in each mode are as follows.
