76
Advanced Operation 5Point the remote control units directly at each
other and press and hold in the button on the
other remote control unit which you want to
“learn”.
•“OK” appears on the remote control unit’s display
and learning is completed.
Other remote
control unit
Other keys can be “learned” by repeating steps 5.
“FAIL” appears on the remote control unit’s display,
repeating steps 4 and 5.
The mode can be switched by pressing a MODE
SELECTOR button.
The buttons that allow learning display reappears and
the learning standby mode is set.
•To cancel the learning mode, press the ON and OFF button
simultaneously again.
Learning function
•If an AV component is not a DENON product, or if it cannot
be operated via codes provided in the AVR-4806 remote
control's internal preset memory, or if its codes cannot be
successfully learned by the AVR-4806 remote control, then
you should use the remote control that was supplied with
that AV component to operate the component.
1Press the ON and OFF button at the same time.
2Press the 2button to select Learning setup.
3Press the MODE SELECTOR button for the
component you want to learned, then press the
ENTER button.
•Buttons that allow learning will light.
Learning is not possible for the AMP, ZONE2, ZONE3
and ZONE4 modes.
4Press the button that you wish to be learned.
•The display will go off and the unit will enter the
learning standby mode.
To cancel, press the ON and OFF button simultaneously.
