(Main unit) (Remote control unit)
Example: Stereo
4Start playback on the selected component.
•For operating instructions, refer to the component’s
manual.
5Adjust the volume.
(Main unit) (Remote control unit)The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –70 to 0
to 18 dB, in steps of 1 dB. However, when the channel
level is set as described on page 23 or page 56, if the
volume for any channel is set at +1 dB or greater, the
volume cannot be adjusted up to 18 dB. (In this case the
maximum volume adjustment range is “18 dB —
(Maximum value of channel level)”.)
Input mode when playing DTS sources
•Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “AUTO” or “DTS”.
Input mode display
•DOLBY DIGITAL
•DTS
This lights, depending on the input signal.
The indicator lights when digital signals are being input
properly. If the indicator does not light, check whether
the digital input component setup (page 28) and connections are
correct and whether the component’s power is turned on.
DIGITAL
DIGITAL
NOTE:
•The indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIGITAL
One of these lights, depending on the
input signal.
