584350
16
Verklein
Vergroot
Pagina terug
1/112
Pagina verder

Getting Started Settings Playback Remote ControlMulti-zone Information Troubleshooting Specifications
Connecting the Speaker
Cables
Protection Circuit
If the core wires touch the rear panel and the
screws etc., or the ± sides touch each other, the
protection circuit will be activated and the power
indicator will flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned off,
after the power supply cord is withdrawn, please
confirm that speaker cable and input cable are
connected.
Also, if replaying large sound levels by using
a speaker having an impedance less than that
specified (eg, 4 Ω/ohms), the temperature will rise,
and the protection circuit might be activated. The
power supply will go into the standby state, and the
power indicator will flash red at 2 second intervals.
In this case, please switch off the power supply,
and wait until the AVR-3310CI has cooled down,
and the surrounding ventilation is good.
Even if there are no problems with the surrounding
ventilation and connections, in the event of the
protection circuit becoming activated, due to
thinking that the AVR-3310CI has failed, please
contact DENON Service center after switching off.
w q
w q
w qw q
*/
w q
(R)
(L) (R)
w q w q
(L) (R) (L)
Subwoofer
Center
speaker
Front
speakers B
Front
speakers A
Surround
speakers
Subwoofer
with built-in
amplifier
NOTE
Connect so that the speaker cable core wires
do not protrude from the speaker terminal. The
protection circuit may be activated if the core
wires touch the rear panel or if the + and sides
touch each other (v“Protection Circuit”).
Never touch the speaker terminals while the
power supply is connected. Doing so could result
in electric shock.
Use speakers with an impedance of 6 to 16 Ω/ohms.
When using front A and B speakers simultaneously,
use speakers with an impedance of 8 to 16 Ω/
ohms.
wq wq
(R) (L)
When in the “Front A Bi-Amp” and “Front B Bi-
Amp” modes, the same signals are output from
the front speaker terminals and the AMP ASSIGN
terminals.
These connections make for higher quality playback
sound with no interference between the signals of
the bass and treble units.
When the “Amp Assign” setting (vpage 34) is
“Front A Bi-Amp” or “Front B Bi-Amp”, connect
as follows. (The illustration shows a connection
example for the Front A Bi-Amp speakers.)
NOTE
Use speakers compatible with bi-amp
connections.
When making bi-amp connections, be sure to
remove the short-circuiting plate or wire between
the speaker’s woofer and tweeter terminals.
Carefully check the left (L) and right (R) channels
and + (red) and (black) polarities on the speakers
being connected to the AVR-3310CI, and be sure to
interconnect the channels and polarities correctly.
When using a banana plug
Tighten the speaker
terminal firmly before
inserting the banana plug.
n
1
Peel off about 0.03 ft/10
mm of sheathing from
the tip of the speaker
cable, then either twist
the core wire tightly or
terminate it.
2
Turn the speaker terminal
counterclockwise to
loosen it.
3
Insert the speaker cable’s
core wire to the hilt into
the speaker terminal.
4
Turn the speaker terminal
clockwise to tighten it.
AVR-3310CI
Front speakers A
Speaker Connections
About Bi-amp Connections
For connections of the SURR. BACK/AMP ASSIGN speaker terminals, see “Set the “Amp Assign”
Mode According to the Speaker Layout” (vpage 12).
Connections
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Denon AVR-3310CI bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Denon AVR-3310CI in de taal/talen: Engels als bijlage per email.

De handleiding is 18,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Denon AVR-3310CI

Denon AVR-3310CI Snelstart handleiding - English - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info