english
33
• Donotoperatechargerwithdamagedcord
or plug — have them replaced immediately.
• Do not operate charger if it has received
a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorized
service center.
• Donotdisassemblecharger;takeittoan
authorizedservicecenterwhenserviceor
repair is required. Incorrect reassembly may
result in a risk of electric shock, electrocution or
fire.
• Disconnectthechargerfromtheoutlet
beforeattemptinganycleaning.Thiswill
reduce the risk of electric shock. Removing
the battery pack will not reduce this risk.
• NEVERattempt to connect 2 chargers together.
• Thechargerisdesignedtooperateon
standard230Vhouseholdelectricalpower.
Donotattempttouseitonanyother
voltage. This does not apply to the vehicular
charger.
SavE THESE INSTRUcTIONS
Chargers
The DE9116 charger accepts DeWALT NiCd and
NiMH battery packs ranging from 7.2 to 18 V.
The DE9135 charger accepts 7.2 – 18 V NiCd,
NiMH or Li-Ion batteries.
These chargers require no adjustment and are
designed to be as easy as possible to operate.
Charging Procedure (fig. 2)
DANGER: Electrocution hazard.
230 volts present at charging terminals.
Do not probe with conductive objects.
Danger of electric shock or lectrocution.
1. Plug the charger (o) into an appropriate outlet
before inserting battery pack.
2. Insert the battery pack (d) into the charger. The
red (charging) light (p) will blink continuously
indicating that the charging process has started.
3. The completion of charge will be indicated by
the red light remaining ON continuously. The
pack is fully charged and may be used at this
time or left in the charger.
Charging Process
Refer the table below for the state of charge of the
battery pack.
State of charge
charging – – – – – –
fully charged –––––––––––
hot/cold pack delay ––– – ––– –
replacebatterypack •••••••••••
problem ••••••••
Automatic Refresh
The automatic refresh mode will equalise or balance
the individual cells in the battery pack at its peak
capacity. Battery packs should be refreshed weekly
or whenever the pack no longer delivers the same
amount of work.
To refresh your battery pack, place the battery in the
charger as usual. Leave the battery pack for at least
8 hours in the charger.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot
or too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has
reached an appropriate temperature. The charger
then automatically switches to the pack charging
mode. This feature ensures maximum battery life.
DEEP DISCHARGE PROTECTION
The battery pack is protected against deep
discharging when it is used in the tool.
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure
to include catalog number and voltage. Consult the
chart at the end of this manual for compatibility of
chargers and battery packs.
The battery pack is not fully charged out of the
carton. Before using the battery pack and charger,
read the safety instructions below. Then follow
charging procedures outlined.
REaD aLL INSTRUcTIONS
• Donotchargeorusebatteryinexplosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Inserting
or removing the battery from the charger may
ignite the dust or fumes.
• ChargethebatterypacksonlyinD
eWALT
chargers.
• DONOTsplash or immerse in water or other
liquids.