17
ENGLISH
Setting up
EXTERNAL UNIT
The external unit may be placed on a terrace
or balcony, in which case the brackets need
not be used.
The external unit can be attached to a wall
with the accessories included as follows:
1) Attach the bracket
to the wall while taking
care to place it as indi-
cated in the drawing.
Use the included tem-
plate located on the
plastic cover in order to
drill the holes.
2) Screw the support
blocks to the exter-
nal unit with the inclu-
ded M4mm screws
while taking care to
place them so that the
hole for the screws is on
the upper side.
3) Attach the external unit
to the bracket by
means of the M6mm
screws .
20
20
16
15
15
For temporary installation it is possible to hang
the external unit as illustrated in the drawing.
In this case, use the included straps by
attaching them to the eye hooks .
Before inserting the eye hooks remove the
rubber plugs.
The external unit may be installed above or at
the same height as the internal unit, on the
condition that the difference is no more than
1.5 m.
The suction and air-delivery portions of exter-
nal unit must not be blocked by obstacles of
any nature.
The distance between the back of the
appliance and the wall must be six (6) cm.
The condensation which forms while this
appliance is running (summertime opera-
tions) is disposed of by evaporation from the
external unit.
If the humidity is
too high (in spe-
cial cases), you
must use the
drainage cou-
pling provided
to get rid of
condensation.
This device must
be mounted on
the bottom of
the external unit
(see drawing) after the rubber plug has been
removed.
We strongly recommend that you protect the
external unit from rain, snow, direct sunlight
and water dripping from the roof.
21
18
17
