18
Turning on and Selecting functions
ELECTRICAL CONNECTION
Before inserting the plug check that:
• the mains supply corresponds to the
power supply shown on the rating plate;
• the socket and the mains lead correspond
to the power requirements of the applian-
ce;
• the socket is suited to the plug, otherwise
have the socket replaced;
• the socket is properly earthed. The manu-
factures cannot be held responsible for
any damages due to failure in following
normal safety procedures.
7
Replacement of the power cable must be
carried out by qualified personnel.
AIR CONDITIONING FUNCTIONS
With the unit turned off, the function selector
is in the “●” position. To turn the unit on in
air conditioning mode, proceed as follows:
1. Rotate the function selector knob clockwi-
se:
• Place the large crystal symbol in line
with the reference mark to operate the
unit in air conditioning mode at maximum
fan speed.
• Place the small crystal symbol in line
with the reference mark to operate the
unit in air conditioning mode at minimum
fan speed.
2. Now set the required temperature by rota-
ting the room thermostat knob .
Note
The temperature is not expressed in degrees.
We therefore recommend rotating the room
thermostat dial to the maximum cool posi-
tion. When room temperature has reached
the required level, rotate the thermostat dial
SLOWLY clockwise until the thermostat is acti-
vated, turning the unit off. This programs the
unit to the precise level of comfort required
which will then be automatically maintained
by the thermostat with considerable energy
savings. When regulating the thermostat, the
air conditioning function is temporarily inter-
rupted and the unit continues to operate in
fan only mode.
Note: cool air is discharged from grill only
after a delay of three to five minutes.
1
15
9
AIR PURIFICATION WITH FAN
Your air conditioning unit has two special high
efficiency electrostatic filters. These filters,
active in all modes, filter out extremely fine
particles (down to 0.3 thousands of a millime-
tre).
If you want to purify the air by ventilating the
room only, rotate the function selector
anticlockwise.
• Place the large symbol in line with the
reference mark to operate the unit in air puri-
fication mode at maximum fan speed.
• Place the small symbol in line with the
reference mark to operate the unit in air puri-
fication mode at minimum fan speed.
9
THIS UNIT EMPLOYS AN EXCLUSIVE CON-
DENSATION RECYCLING SYSTEM TO DISPO-
SE OF EXCESS MOISTURE. IN NORMAL
CONDITIONS, CONDENSATION IS DISPO-
SED OF AUTOMATICALLY. WHEN THE HUMI-
DITY IS PARTICULARLY HIGH, AN EXCESS OF
CONDENSATION MAY BUILT UP IN THE TANK
. WHEN THIS HAPPENS, THE INDICATOR
LIGHT COMES ON INDICATING THAT
THE TANK SHOULD BE EMPTIED. ONLY FOR
SOME MODEL: WHENEVER CONDITIONS OF
HIGH HUMIDITY MAKE THE PROBLEM
RECURRENT, YOU MAY DISCHARGE THE
EXCESS WATER DIRECTLY INTO A DRAIN,
USING A RUBBER TUBE WITH AN INTERNAL
DIAMETER OF 12 MM; THE TUBE SHOULD BE
INSERTED INTO THE HOLE PROVIDED, AFTER
HAVING REMOVED THE RUBBER STOPPER.
(see figure below).
MAKE SURE THE TANK IS PUT BACK COR-
RECTLY OTHERWISE THE LIGHT WILL
REMAIN ON.
14
14
5
