29
USING THE REMOTE CONTROL UNIT (FIG. 21)
The ON/Standby, MODE, FAN + and - buttons correspond to the
equivalent buttons on the control panel.
ON/STANDBY BUTTON: Turn the appliance on and off.
MODE BUTTON: Select modes: AIR CONDITIONING, DEHUMIDIF-
YING, AIR PURIFYING, FAN, HEATING, SMART
FAN BUTTON: selects fan speed (High, Medium, Low, Auto)
+ and - BUTTON: increase and decrease
To use these buttons see the section "Operating from the control
panel".
The following section describes the additional functions corre-
sponding to the controls on the bottom part of the remote con-
trol.
SELECTING THE TEMPERATURE SCALE (FIG. 22)
Press the button to switch the temperature display from
degrees Centigrade to degrees Fahrenheit and vice versa.
S
ETTING THE TIME
After having inserted the batteries, the clock on the display flas-
hes until the time is set.
Proceed as follows:
•Press the + or - button until the correct time is reached. Hold the button down to run rapidly
through first the minutes, then the tens of minutes and then the hours.
•Once the correct time has been reached, press the SET button to confirm.
If you need to change the time later, press the SET button, then set as described above.
To cancel the settings programmed on the remote control and restore the original settings,
press the RESET button lightly with the point of a pencil or pen.
INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control (fig. 20);
• Insert two R03 “AAA” 1.5V batteries in the correct position (see
instructions inside the battery compartment);
• Replace the cover.
If the remote control unit is replaced or disposed of,
the batteries must be removed and discarded in
accordance with current legislation as they are harm-
ful to the environment.
✔
29
20
22
21
