4
ELECTRICAL CONNECTION
- Before using the appliance check that your supply voltage is the same of that shown on
the rating label of the unit.
- THIS APPLIANCE CONFORMS TO DIRECTIVE 89/336/CEE GOVERNING RADIO
INTERFERENCE.
INSTALLATION
The heater can be used on a horizontal surface.
Models with a motorised base can be wall-mounted, using 3 screws and 3 wall plugs.
To wall-mount, proceed as follows:
Drill holes in the wall, as shown in Fig.1, paying particular attention to the minimum distances
indicated.
When the appliance is used in bathroom, remember to position it outside the areas in which
the presence of water may represent a source of danger (fig.3).
The appliance must not be positioned directly underneath a fixed power
point.
FUNCTIONING AND USE
Models with function selector and ambient thermostat
-
Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum setting.
-
Summer service (ventilation only): turn the knob to setting .
-
Heating at reduced power: turn the knob (left) to setting 1 (the pilot light will come on).
-
Heating at full power: turn the knob (left) to setting 2.
-
Switching off: turn the knob (left) to setting 0.
Setting the thermostat:
When the room has reached the desired temperature, turn the thermostat dial slowly in an
anti-clockwise direction until the the pilot light goes out. The thermostat will then automati-
cally maintain the desired temperature level.
ANTIFREEZE SERVICE
Turn the left knob to setting 2, then turn the right thermostat knob to setting . When it is set
in this way the appliance keeps the room at a temperature of approx. 5° C with minimal
energy expenditure.
Models with function selector only
Summer use: turn the function selector dial clockwise to position .
Min power operation: turn the function selector dial to position 1 (the pilot light will come on).
Max power operation: turn the function selector dial to position 2.
Switching the appliance off: turn the function selector to position “O”.
MODELS WITH 24 HOUR TIMER
To set the heating periods proceed in the following manner:
- Check the time by your watch. Supposing it is 10.00 a.m. turn the numbered dial of the
time-clock in a clockwise direction until the number 10 coincides with the reference mark
▲ on the time-clock. Set the time period during which you wish the appliance to work by
pushing the notches towards the centre. Each notch corresponds to a period of 15 minu-
tes. At this point red sections will be visible corresponding to the working periods. Set in
this way the fan heater will function automatically every day during the set period. (Impor-
tant: the plug must always remain connected to power supply).
- To change the programmed time period, just bring back the black notches to their original
position and set the new working periods required.
- If you wish the appliance to function without programmed working periods push all the
GB
