Voltage/ Wattage See rating label
ELECTRICAL CONNECTION
- Before plugging in the heater, check that the voltage of your domestic supply cor-
responds to the voltage (V) indicated on the rating label of the heater and that the
socket and power line are appropriately dimensioned.
- THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336, RELATING TO ELEC-
TRO-MAGNETIC COMPATIBILITY.
- When you plug in the appliance, the red pilot light will illuminate (Fig. 1).
INSTALLATION
The appliance requires no installation; it should be used solely as a portable
appliance on an horizontal surface.
Portable appliances are not suitable for use in a bathroom.
OPERATION AND USE
1) SETTING THE CLOCK
For the first time, set the clock to the correct time, proceeding as follows:
• Press the “hour” button until the display shows the hours for the correct time,
then release the button (fig.1).
• Press the “min” button until the display shows the minutes for the correct time,
then release the button (fig. 1).
When setting the correct time, the numbers will flash on the display.
The clock will continue to flash for a few seconds after the adjustment has been
made, then stop on the correct time and start working.
(To move through the hours or minutes in fast mode, keep the relevant button pres-
sed down for longer than 3 seconds).
To change the time, press the “hour” button for at least 5 seconds, then proceed
as above to modify both hours and minutes.
2) MOTORISED BASE/OSCILLATION
Press the foot switch and the heater oscillates through 180° on its base, therefore
heating/cooling a larger area. To stop the heater oscillating , press the foot switch
again.
3) OPERATION OF HEATER (without timer)
To operate the heater without timer press the “MANUAL FUNCTION” button. (Fig.
1). By pressing the “MANUAL FUNCTION” button one or more times, the applian-
ce will select the operating heating power, as follows:
Maximum power
