40
5/ DETERGENT PRODUCTS AND SETTING THE WATER SOFTENER
EN
• FOR TRADITIONAL PRODUCTS
Important:
It is very important to set your water softener correctly.
- If the setting is too low, there is a risk of chalky marks
- If the setting is too high, there is the risk of the glasses becoming cloudy
If you move house, re-adjust the setting on your water softener.
• Traditional tablets
Place tablets that are not multi-purpose in the external compartment (Fig 04)
or, for optimum operation, pull out the distributor’s drawer and lay the tablet there. (Fig 05)
• Powder or liquid in the distributor’s drawer (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and up to the maximum mark for dirty
crockery. If the crockery is very dirty or for programmes with pre-wash, we recommend that you
add 5g of detergent (a dessertspoonful) to the tub in accordance with the programmes table.
Important:
Keep these products in a dry place, out of children’s reach.
Only use products specially designed for dishwashers.
•
Your appliance must be specially set to use traditional products
.
• Proceed as follows to adjust the water softe-
ner on the control panel:
— Access setting mode by holding down the “Set ” button
until you hear a double audible signal (long beep).
— The screen displays “SEt” to indicate that you are in
Setting mode.
— To adjust and alter the setting to suit the water hardness, keep on briefly pressing one of the
keys or the other. The screen shows you the setting c0, c1, c2 etc...
— The setting is validated automatically after 10 seconds if the
“Set”
button in not pressed again.
Fig. 04 Fig. 05Fig. 03
Factory setting: c3.
TTeessttiinngg
ssttrriipp
HHaarrddnneessss
0-10°F 10-25°F 25-40°F 40-55°F 55-70°F > 70°F
SSeettttiinngg
TTrraaddiittiioonnaall
pprroodduucctt
c0 cI c2 c3 c4 c5
