49
9/ SETTING THE PARAMETERSEN
• SETTINGS POSSIBLE USING THE “SET” AND SELECTION BUTTONS:
1 long
press
•
1 long press on the “
SET”
button and then a short press
enables you to move on to the following parameters.
Set the parameters by pressing one of the programme
selection buttons or the other.
Move on to the next parameter by pressing “S
ET
”.
Display
Briefly
press
the “SET”
button once
and then
press one
or
other of the
selection
buttons
Advice:
The setting is confirmed automatically when you move on to the next parameter or if the
“Set” button is not pressed again within the next 10 seconds.
> Setting the clock (hour)
To do this, hold down the “S
ET” button. When the
time starts to flash, press one of the selection but-
tons or the other until you reach the desired time.
Press S
ET
to move on to the next parameter.
> Setting the clock (minutes)
Proceed in the same way as above; press one of the
selection buttons or the other to set the minutes.
> Setting the water softener
Set to the level corresponding to the hardness of
your water:
cc00
to
cc55
.
> Product use
You can cancel display of the relevant indicators,
depending on the products used:
- Salt Set to
OOFFFF
if you do not use salt or f you
are using multi-purpose tablets.
- Rinsing product Set to
OOFFFF
if you do not use a
rinsing product or if you are using multi-purpose tablets.
> Multi-purpose tablets: only for
cc00
or
cc11
activate the “
AUTO
4/1” option
- For optimum product performance (depending on
the water softener setting table on page 43), set:
- To deactivate the “4/1” option.
- to select “4/1” with “Extra Dry”
- to select “4/1” with “Sparkling Clean”.
> Beep at the end of the programme
OOnn
to activate the function;
OOFFFF
if you do not wish not
to hear the beep at the end of the program.
> Screen brightness
Set the screen brightness to suit yourself from
LLuu11
minimum to
LLuu55
maximum.
oorr
