- Wrongly programmed.
- No salt or too little salt
in the reservoir to trig-
ger the float.
- Insufficient amperage to
supply all the equip-
ment being used at the
same time.
- Internal fault in the
machine
- No power supply to the
socket
- The tap is closed
- The water supply hose
is kinked
- Programme selection
error and programme
blocked
- Start button held down
too long (> 2 seconds)
- Safety system (anti-leak)
- Protective cover on the
sinks U bend not removed
- Drainage hose kinked
- Drain filter totally
blocked
- Pump blocked.
Présentation de votre lave-vaisselle
48
- Cancel the current pro-
gramme by holding
down the Start button
for 3 seconds and then
reprogramme.
-
Fill the reservoir and
wait until the cycle
ends. If the water is
soft enough not to
require salt, the Salt
light is permanently lit.
- Check the plugs ampe-
rage (10A minimum)
and the meters capacity
- Call an engineer.
- Check the socket and
the fuse
- Check that the tap is
open
- Check that hose run
- Cancel by pressing
Start for 3 seconds
and reprogramme
- Press Start only briefly
to start the programme
- Call an engineer.
- Remove the protective
cover
- Check the hose runs cor-
rectly behind the machine
- Remove the filters and
clean them and the
drain hole
- Start a Drenching pro-
gramme. If the fault
persists, call an engi-
neer.
The lights light up one
after another
The Salt light does not go
out
The machine cuts off
The machine will not
start
The machine does not
drain.
Advice, an anomaly, what to do?
Programming, display anomalies
Possible causes What to do
Poor operation Possible causes What to do
