Names of Parts
Indoor Unit
Appearance of the indoor unit may differ.•
Air inlet
Upper front
panel
Air outlet
Louvres (vertical blades)
The louvres are inside of the air outlet. •
Page 13
INTELLIGENT EYE
sensor
It detects the movements •
of people and automatically
switches between normal
operation and energy
saving operation.
Page 15
Flaps
(horizontal
blades)
Page 13
INTELLIGENT EYE lamp
(green)
Page 16
Signal receiver and Indoor
unit ON/OFF switch
Signal receiver
It receives signals from the remote •
controller.
When the unit receives a signal, you will •
hear a beep sound.
Case Sound type
Operation start beep-beep
Setting changed beep
Operation stop long beep
Indoor unit ON/OFF switch
Press this switch once to start operation.•
Press once again to stop it.
For the operation mode setting, refer to the following •
table.
Mode Temperature setting Airfl ow rate
AUTO 25°C AUTO
This switch can be used when the remote controller is •
missing.
TIMER lamp
When operation by timer has been set, the multi-monitor lamp •
periodically changes to orange. After lighting orange for about
5 seconds, it returns to the colour of the operation mode.
The multi-monitor lamp will turn orange on and off in cyclic
manner while the air conditioner is not in operation.
Indoor temperature
sensor
It detects the air •
temperature around the
unit.
Multi-monitor lamp and
TIMER lamp
Multi-monitor lamp
The lamp colour changes according to •
the operation.
Operation Multi-monitor lamp
AUTO Red/Blue
DRY Green
COOL Blue
HEAT Red
FAN White
TIMER Orange
Lower front panel
It is located on the back of the •
upper front panel during operation.
