2) Connect the device cable to the external cable according to the use
requirements, and use insulated rubber tape to twist the cable connection
well to make it waterproof.
Note
Please be aware that the bending radius needs to be no less than 30mm
when connecting to optical fiber.
3) Install waterproof connector
Figure 3-3
a) Keep the convex groove outward and install the rubber ring into
the network port, and keep the smaller hole of the rubber ring
outward and install the fixing rubber ring into the main body of the
waterproof connector.
b) After pulling the network cable without crystal head through main
body of waterproof connector, fixing rubber ring and waterproof
fastening cover, make the crystal connector of network cable and
then insert it into the network cable.
c) Put the main body of waterproof connector on the network port and
rotate it clockwise to lock the network port and waterproof
connector firmly.
d) Put the waterproof fastening cover on the main body of waterproof
connector and rotate it clockwise to lock the waterproof connector
and waterproof fastening cover firmly.
4) Stuff the cable into the installation bracket after connection.
Step 7 Fix the device on the installation bracket.
1) Put the device into the adapter block and tighten it firmly by anti-drop
screws.
2) Adjust the monitoring angle according to the use requirement.
3) Use the locking screws to fix the device.
