7
MANUAL CHANNEL TUNING AND FINE TUNING
1.Manual Channel Tuning
Choose a starting point
- Select with “Program” the program from which you want to start
manual tuning.
Then the program number, the frequency, the name and the program
number of this program are displayed in the install menu.
2.Channel searching
- Select the “Freqency” function.
- Press, and hold for more than 1 second, the remote control C
/
B
buttons to start up [down] manual tuning.
- Searching will stop automatically at the next channel found (to stop
tuning, press the remote control MENU button.)
Note : You can directly locate a program by entering the data into the
“Program” or the “Frequency” function.
3.Perform fine tuning
- If you are unable to get a good picture or reasonable quality sound
due to poor reception, it is possible to perform fine tuning.
- Select the “Frequency” function.
- Press, for less than 1 second, the remote control C
/
B buttons to
perform up [down] fine tuning in steps of 0.05MHz (50KHz)
4. Store program in memory
- Select the “Store to” function.
- Enter the program number you want to store to either by using the
remote control C
/
B buttons, or directly by using the remote control
NUMBER 0...9 buttons.
- Press the OK button to confirm.
Remarks : This function can also be used if you want to copy a program
already memorised to another program number.
ENTER A STATION NAME
It is possible to enter your own choice of name for each program. You
can change an existing name, or enter a name where none exists. If
none exists “-----” will be shown in the Install menu, and program status
display.
- Select the “NAME” function.
- Select one of the 5 character positions by using the remote control
C
/
B buttons to move the cursor.
- Then use the PR y
/
x buttons to select the desired character for that
position.
