3
EARTHING INSTRUCTIONS
This appliance must be earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a
cord having a earthing wire with a earthing plug.
The plug must be plugged into an outlet that is
properly installed and earthed.
WARNING : Improper use of th earthing plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the earthing
instructions are not completely understood, or if
doubt exists as to whether the appliance is
properly earthed. If it is necesary to use an
extension cord, use only a 3-wire extension cord
that has a 3-blade earthing plug, and a 3-slot
receptacle that will accept the plug on the
appliance. The marked rating of the extension
cord should be equal to or greater than the
electrical rating of the appliance.
IMPORTANT
The wires in this mains lead fitted to this appliance
are colored in accordance with the following code.
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows : the wire which is colored
green-and-yellow must be connected to the
terminal in the plug which is marked with the letter
‘E’ or by the earth symbol or green-and-yellow.
The wire which is colored blue must be connected
to the terminal which is marked with the letter ‘N’
or colored black. The wire which is colored brown
must be connected to the terminal which is
marked with the letter ‘L’ or colored red.
WARNING : The appliance must be earthed.
INSTALLATION
1. Ventilation
Do not block air vents. If they are blocked
during operation, the oven may overheat and
eventually cause a failure. For proper
ventilation, allow above 76mm of space
between oven sides, rear and the minimum
height of free space necesary above the top
surface of the oven is 150mm.
2. Steady, flat location
This oven should be set on a steady, flat
surface. This oven is designed for counter top
use only.
The microwave oven shall not be placed in a
cabinet unless it has been tested in a cabinet.
3. Leave space behind and side
All air vents should be kept a clearance. If all
vents are covered during operation, the oven
may overheat and, eventually, oven failure.
4. Away from radio and TV sets
Poor television reception and radio interference
may result if the oven is located close to a TV,
Radio antenna, feeder and so on. Position the
oven as far from them as possible.
5. Away from heating appliance and water taps
Keep the oven away from hot air, steam or
Splash when choosing a place to position it, or
the insulation might be adversely affected and
breakdowns occur.
6. Power supply
• Check your local power source. This oven
requires a current of approximately 10
amperes, 230V 50Hz.
• Power supply cord is about 1.0 meters long.
• The voltage used must be the same as
specified on this oven. Using a higher voltage
may result in a fire or other accident causing
oven damage. Using low voltage will cause
slow cooking. We are not responsible for
damage resulting from use of this oven with a
voltage of ampere fuse other than those
specified.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard.
7. Examine the oven after unpacking for any
damage such as:
A misaligned door, Broken door, A dent in
cavity. If any of the above are visible, DO NOT
INSTALL, and notify dealer immediately.
8. Do not operate the oven if it is colder than
room temperature.
(This may occur during delivery in cold
weather.) Allow the oven to become room
temperature before operating.
