- Project from frost, Remove thr filter cartridge if you expect
the temperature to drop below freezing
- Do not install the water filter if the water pressure is greater
than 0.86MPa(8.6bar).
If the water pressure is greater than 0.55MPa(5.5bar), a
pressure reducing valve must be fitted. If you are not sure
what the water pressure is, contact an installation expert.
- If pressure surges could occur in the water pipe. do not
install the water filter without a suitable surge eliminator.
Contact an installation expert if you are not sure whether
pressure surges could occur in the water pipe.
- After installing a new filter:
Discard any ice produced in the first 24 hours after
switching on.
- If no ice has been removed for a lengthy period: Empty the
ice box and discard any ice produced over the next
24hours.
How to install Water Line
(Dispenser Models Only)
1. The water pressure should be 2.0~12.5 kgf/cm2 or more
to run the automatic icemaker.
Checkup your tap water pressure ; if a cup of 180cc is
full within 10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not
close to any hot surfaces.
3. The water filter only filters water ; it does not eliminate
any bacteria or microbes.
4. If the water pressure is not so high to run the icemaker,
call the local plumber to get an additional water pressure
pump.
5. The filter life depends on the amount of use. We
recommend you replace the filter at least once every
6months.
6. After installation of refrigerator and water line system,
select [WATER] on your control panel and press it for
2~3 minutes to supply water into the water tank and
dispense water.
7. Use sealing tape to every connection of pipes/tubes to
ensure there is no water leak.
8. The water tube should be connected to the cold water
line.
WATER SUPPLY KIT
Check the parts below for installing water supply.
Some other necessary parts are available at your
local service agents.
Installation Procedure
(Dispenser Models Only)
1. Join Connector to the tap water line
Figure A
Figure B
Place the rubber washer inside the tap connector
and screw onto the water tap.
2. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube.
(Be careful to follow the direction of the nut.)
3) Insert the Water Tube into the top of the Water Valve,
turn the nut clockwise to fasten it. (The Water valve is to
the right of the motors.)
4) Check for any bent tubes or water leaks; if so, re-ckeck
instalation procedure.
5) Replace the rear cover. (The Water Tube should be
placed between the groove of the refrigerator back and
motor cover.)
Set the tube upright as the figure shows.
3. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on the
control panel for 2~3 minutes to remove any air (bubble)
in the pipes and drain out the initial water.
2) Check for the water leaks again through the water supply
system (tubes, connectors and pipes) Rearrange the
tubes again and do not move the refrigerator.
14 15
enen
