571631
7
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
English
INSTALLATION MANUAL
Follow the procedure described below:
Ø
Disconnect the pipes from the gas control (flexible gas pipe, aluminium pilot burner pipe and thermocouple 1);
!Caution
The red wire of thermocouple 2, if applicable, must remain connected to the gas control.
Ø
Disconnect the gas control from the burner mounting plate by unscrewing the self-tapping screw.
Ø
Carefully unwind the red and black wire of thermocouple 2, if applicable.
Ø
Carefully lay the gas control together with the wires of thermocouple 2, the ignition cable, the flexible gas hose,
the aluminium pilot burner pipe and the type plate plus chain in the direction of the control hatch.
!Caution
Prevent dirt in gas pipes and connections;
Avoid kinks in the pipes.
!Caution
Make sure the ignition cable cannot come into contact with other wires;
The data plate should remain attached to the chain.
Ø
Set the height of the appliance using the adjustable feet (if applicable).
Ø
Make the appliance level at the same time.
!Tip
The construction frame for most 2 or 3 sided appliances can be adjusted. This will allow you to connect the
construction frame to the chimney breast correctly. For 2 or 3 sided appliances that cannot be adjusted, we would
like to refer you to chapter 5.9 'Additional instructions'.
!Caution
do not ignite the appliance before the gas and discharge connections have been fully installed, first observe the
procedure described in chapter 7.3.
5.5Placingthechimneybreast (if applicable)
In order to provide proper heat discharge, there should be sufficient space around the appliance. The chimney
breast should be ventilated sufficiently by means of ventilation holes (incoming and outgoing).
!Caution
Use non combustible and heat-resistant material for the chimney breast, including the top of the chimney
breast, the material inside the chimney breast and the back wall of the chimney breast.
Make sure that the appliance is not carrying the weight of the chimney breast when using stone-like
materials.
The passage of the ventilation holes (outgoing), which are placed as high as possible, is stated in Appendix 2,
Table 2.
!Caution
When placing the chimney breast, you should take the following into account (see Appendix 3, fig. 2):
the location of the control hatch: this must be placed as low as possible;
the dimensions of the control hatch; see Placing the control hatch section 5.6;
the Dru control hatch is not supplied with all appliances. Nevertheless, we recommend only using a Dru
control hatch, if available, exept in the case of B 11 AS/BS appliances. If you decide not to take this option, you
will have to make a 100 cm2 ventilation hole that is placed as low as possible, for the benefit of the incoming
ventilation;
the location of the ventilation holes (V) (outgoing);
maintain a minimum 30 cm distance between the top of the ventilation hole (outgoing) and the ceiling of the
house.
the measurements of the glass pane, so that it can be placed/removed after placing the chimney breast;
the protection of the gas control and the pipes against cement and plaster.
If possible, you should place decorative strips, frames, etc., after any required structural work has been
completed. Avoid the use of painter's tape. If this is not possible: please use good quality painter's tape and
remove it immediately after plastering or painting work has been completed.
!Tip
You should preferably apply the ventilation holes (outgoing) on both sides of the chimney breast. You can use
DRU ventilation elements.
Prior to completely closing the chimney breast, check whether the discharge / concentric system is placed
correctly.
whether the channels, fixing brackets and possible clip bindings, which cannot be reached after installation,
are fastened by means of self-tapping screws.
7
7

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

DRU-Diablo-Next

Zoeken resetten

  • Wij hebben een dru diablo uit 2000 heeft het erg goed gedaan alleen nu vonkt hij niet meer,hebben een nieuwe bougie gekregen en die doet het ook niet.wat zou de oorzaak kunnen zijn,zoms vonkt hij wel en dan doet hij het goed. Gesteld op 6-9-2023 om 12:32

    Reageer op deze vraag Misbruik melden
  • wanneer ik met het gasregelblok te haard wil activeren gebeurt er niets Gesteld op 29-10-2020 om 14:46

    Reageer op deze vraag Misbruik melden
  • Hoe kan ik de ruiten aan de binnenkant schoonmaken, hoe kom ik daarbij? Gesteld op 25-6-2016 om 12:40

    Reageer op deze vraag Misbruik melden
  • de aftandbediening heeft nieuwe baterijen. Nu wil hij wel dimmen maar niet feller branden
    Ook de batterijen in de ontvanger zijn vervangen
    Gesteld op 16-3-2016 om 14:07

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw DRU Diablo Next bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van DRU Diablo Next in de taal/talen: Engels als bijlage per email.

De handleiding is 4.59 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van DRU Diablo Next

DRU Diablo Next Installatiehandleiding - Nederlands - 36 pagina's

DRU Diablo Next Gebruiksaanwijzing - Nederlands - 20 pagina's

DRU Diablo Next Gebruiksaanwijzing - Nederlands - 16 pagina's

DRU Diablo Next Installatiehandleiding - Deutsch - 36 pagina's

DRU Diablo Next Gebruiksaanwijzing - Deutsch - 20 pagina's

DRU Diablo Next Gebruiksaanwijzing - English - 20 pagina's

DRU Diablo Next Gebruiksaanwijzing - Français - 20 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info