22
A locking pin is integrated into the
catch on the right side, and prevents
accidental folding.
The transporters are fitted with 20” spoked wheels and tyres dimension 47-406 (20” x 1.75”)
Both ends of the handlebar are pushed into the tubes at the upper rear section of
the transporter framework.
Assembly: Press on the rubber cap
and insert the clevis axle into the hol-
low axle until it engages. Repeat this
on the other side and check that the
wheels cannot be pulled off.
Engaged lock
Please note:
The auxiliary lock on the right side
must be released each time before
folding, otherwise you will damage the
transporter frame. See also:
Instructions for folding (Section 1.5.)
1.1.3. Wheel Assembly on Models 535 and 737
1.1.4. Fitting the Handlebar
When the handlebar holes are properly
aligned with the frame tubes, lock them
on each side with the spring clip bolt,
which you push through from outside
inwards, and then secure with the
spring clip loop. Ensure that you pull
the spring clip loop over the end of the
bolt so that the end of the bolt is com-
pletely surrounded by the clip opening.
The handlebar can be adjusted for two
positions. The lower position is howe-
ver only intended for small people or
children.
Please note:
In the event of the vehicle tipping over,
the handlebar grip acts as a safety bar.
So keep it permanently installed, even
when using the transporter behind a
bicycle!
Tip:
Fitting the spring clip bolt is made
easier if you release the
folding catches and slightly fold the
trailer.
Tip:
If the handlebar sticks, try using soap
or silicon spray!
