32
4. The Jogging Kit
4.1. Fitting the Jogging Kit
4.1.1. Fitting the Wheel Arms
Put both wheel arms on the correct
side of the carrier as shown in the pic-
ture
Follow the same procedure for inserting and locking the wheel arms as for
the drawbar.
4.1.2. Fitting the Front Wheel
Insert the wheel axle into the dropouts of
the wheel arms and align the wheel in
direction of travel.
Tighten the adjusting nut of the opened
quick release clockwise until the
supporting surfaces of the quick
release are up against the dropouts.
Open the quick release lever as far as
possible. It may be necessary to loosen
the adjusting nut of the quick release by
a few turns so that the axle can be
pushed into the dropouts.
The quick release is properly adjusted
when you can clearly feel resistance as
you tighten. You should feel this resi-
stance about 60° before the final point
in the lever movement.
Close the quick release.
Please note:
If the quick release is tightened too
much, the plastic dropouts can be
damaged and so impair proper
functioning.
Tip:
Any deviation of the jogger from a
straight line when in use can be
corrected by further alignment of
the front wheel.
• Please always try to avoid pushing your buggy over obstacles (e.g. kerbs) particularly if it is heavily loaded, otherwise it
could get damaged.
• When the transporter is used behind a bicycle the buggy wheel must always be detached, otherwise it may catch on
obstacles. This could lead to damage and accidents.
noticeable
resistance fix the lever properly