Hold the bobbin between the thumb and
forefinger of your right hand and pull out approx.
15 cm of thread.
1. Keep the bobbin case in your left hand,
and place the bobbin into the bobbin case.
2.Draw the end of the thread into the slot at
the edge of the bobbin case.
3. Now you draw the thread all the way through
under the tension spring until it reaches the
notch. Make sure to pull out approx. 15 cm
of thread
Inserting the bobbin case and the bobbin:
4. Hold the bobbin case so that the
long lever of the case points upward. Open
the latch of the bobbin case.
5. Slide the bobbin case onto the pin in the
middle, and push as far as it goes, until the
long lever of the bobbin case attaches to the
shuttle hook. Release the latch, and press
onto the bobbin case.
6. Close the bobbin case cover (7).
1
2
3
4
5
6
13
Threading the bobbin case
Bobbin case
Bobbin
Slot
Tension spring
Notch
Latch
Latch
Long lever
