736569
12
Verklein
Vergroot
Pagina terug
1/47
Pagina verder
12 GB/IE
Getting started
do not use the device for approx. 4 minutes, the com-
puter
8
will automatically switch itself off.
Q
Choosing the display
While you are exercising, the first line of the
display
12
shows
– “STOP“ as soon as you stop exercising
the number of steps per minute (estimated
figure)
Q
Choosing the mode
The second line of the display
12
will display vari-
ous exercise data (modes). Briefly press the MODE
button
13
to change from one mode to another.
1. “TMR“ (lights up): time exercised so far, 0:00
to 99:59
2. “REPS“: Number of steps in the current exercise
session, 0 to 9999
3. “CAL“: the number of calories used
1
), 0 to
9999
4. “TTR“: Number of training steps in total since
the batteries were inserted, 0 to 9999
If you wish to see all exercise data one after the
other, press the MODE button
13
as often as nec-
essary until the “TMR“ flashes in the display. The
display
12
will automatically change from one mode
to the next every 5 seconds.
1) The calculation is based on pre-programmed
standard values that can only serve as a guide-
line. The calories consumed by using the elastic
cords are not taken into account.
Q
Specifying exercise objectives
You can specify one or several objectives:
– Duration of exercise session (TMR)
– Number of steps (REPS)
– Calorie consumption (CAL)
1. Press the MODE button
13
down until “0:00
(TMR)“ appears in the second line of the display
12
and the first 0 flashes (approx. 4 seconds).
2. In order to specify the duration of an exercise
session, press the MODE button
13
as often as
necessary until the display
12
indicates the
desired duration in minutes.
3. Wait a few seconds until the display
12
shows
the next mode (REPS). Press the MODE button
13
to set the desired number of steps, in increments
of 10.
4. In the next mode (CAL), you can set the desired
calorie consumption, in increments of 10.
5. Start exercising. The computer
8
will count
down the preset values until they reach zero
and this will be indicated in the display
12
.
6. When the set objective has been achieved, the
computer
8
will stop counting for about
10 seconds.
Then the computer
8
will start again at zero.
Q
Resetting the display
The display
12
will only be on zero before your first
exercise session. With every subsequent exercise
session, the computer
8
will continue counting from
where it left off in the last exercise session.
You can reset the display by pressing the MODE
button
13
down until all the symbols can be seen
at the same time. You can reset the total number of
training steps (TTR) by removing the batteries.
Q
Replacing the batteries
j Make sure the display
12
is off before removing
and inserting battery.
j Pull the computer
8
upwards so that it comes
off the casing.
j Remove the used battery and dispose of it in
an environmentally friendly way (see section
called “Disposal“).
j Insert a new 1.5 V
AAA battery into the bat-
tery compartment on the lower side of the com-
puter
8
. Ensure correct polarity. Ensure that
the plug
10
is correctly plugged in. Insert the
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Crivit Z29550 IAN 53313 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Crivit Z29550 IAN 53313 in de taal/talen: Engels, Deens als bijlage per email.

De handleiding is 1,74 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Crivit Z29550 IAN 53313

Crivit Z29550 IAN 53313 Gebruiksaanwijzing - Nederlands, Deutsch, Français, Italiano - 40 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info