iAUDIO U5
19
4. Launch Windows File Explorer or JetAudio.
5. You can copy any files including MP 3files to and from “iAUDIO” Drive
6. To disconnect the player from the PC, first make sure that file transfers are complete and then, single-click on icon on the windows tray.
7. Click on the following pop-up message when
it appears
8. When “Safely Remove Hardware” message appears, and the TFT LCD displays a battery you may disconnect the USB cable.
8. Connecting to PC and Transferring Files
1. Connect the player to a PC
using the supplied USB cable.
2. When connected, the screen will show
the following screen.
3. The iAUDIO drive will appear as
shown and can be accessed like a
disk drive using Windows Explorer
- The iAUDIO U5 can recognize up to 500 folders and 2000 files.- If iAUDIO drive does not appear in either My Computer or Windows
Explorer, check the connection and settings, and then re-connect (Separate driver installation is required for Windows 98).
- If the USB cable is connected after running ‘Safely Remove Hardware’ wizard from the steps listed above, the player stays in the battery
charging mode. To access its memory, iAUDIO must be disconnected first and reconnected.
- If the device is connected through a USB HUB, the device won’t be charged. The device must be connected directly to a USB port installed
on a PC.
- The ‘safely remove hardware’ icon may not appear in windows 98/98SE. In such case, close JetAudio, then remove USB cable to disconnect.
- If the following message appears, run Safely Remove Hardware after a few minutes.
Introducing iAUDIO U5
