13
3. User manual
- Always make sure that the instructions in this user manual are followed precisely. If these instructions
are not followed correctly, this can result in fire or explosion that could cause damage to persons,
property or loss of life. Never use flammable liquids or vapors in the vicinity of a burning device.
- Improper installation, adjustments or modifications to the equipment can result in injury or property
damage. Read the installation instructions, safety precautions and operating instructions very
carefully.
- Do not leave the Cosiscoop Pillar unattended when it is in use or when it is connected to a gas
cylinder.
- What to do if the device emits a smell of gas:
o Shut off the gas bottle immediately and contact a technical gas specialist. Do not use the
device until it is approved for use again.
- Installation, maintenance and service needs to be performed by a qualified gas technician in these
cases.
- Only use the Cosiscoop Pillar outdoors or in a well-ventilated area. Never use the Cosiscoop Pillar
inside a building, house, garage or any other enclosed area.
- Gas bottles must be stored outdoors and in well-ventilated areas. Make sure that gas bottles are out
of the reach of children.
- The Cosiscoop Pillar is best stored in a garage or well-ventilated area. Store the Cosiscoop Pillar only
when it is disconnected from the gas bottle.
- The Cosiscoop Pillar is not qualified as a cooking appliance and therefore must not be used as a
cooking appliance.
- Check for gas leaks at least once a month and every time a change is made to the unit.
- Keep the area around the Cosiscoop Pillar clear of combustible liquids, materials and vapors. Never
throw anything into the flames of the Cosiscoop Pillar.
- Never use a fuel other than propane gas.
Turning on the Cosiscoop Pillar
- Make sure the Cosiscoop Pillar is stable and secure.
- Remove the protective cover and make sure the fuel supply is properly connected and turned on at
the gas tank.
- Keep the control button pushed in when you open the gas supply and turn the control button to
‘HIGH’ for gas supply. The burner should now ignite within 15 seconds. When the burner produces a
complete flame, hold the control button for another 15 seconds. The flame should keep burning now.
In case the flame goes out however, you should turn the control button to ‘OFF’, close the gas bottle
and wait 5 minutes. Now re-open the gas bottle and try the same process again. This time hold the gas
supply button a little longer.
- Ready to use the Cosiscoop Pillar for the first time? Make sure that the device is turned on at the highest
setting for 15 minutes. This way, the pebbles are heated through and this ensures that any bumps or air
bubbles will disappear from the pebbles. Keep at a safe distance of at least 2 meters while using the
device for the first time. Due to air bubbles burning out of the pebbles, the rocks may jump up lightly.
This can also happen when the pebbles have become wet.
Switching off the Cosiscoop Pillar
- Turn the control button towards ‘OFF’ to extinguish the flame. When the flame is extinguished
entirely, you shut off the gas valve on the gas bottle.
- Let the pebbles and glass cool down completely and place the protective cover over the Cosiscoop
Pillar.
