•Set the temperature level of switch P1 by pressing, or pressing
repeatedly, the large........or........button on the front panel of the
device. (The temperature can be set in 0.5°C increments).
•Pressthe“PROG” button again. At this point the next programming
step should be performed, i.e. the starting time of switch P2
should be set. As in the previous steps, the time value to be set
will flash on the display.
• Ifyoudonotneedallthesixswitcheseveryday,thenyoucan
omit the switch adjustment by pressing the “DAY” button while
the temperature or time of the unnecessary switch is being set.
The display shows this process by means of lines (- - - -), which
appear on the time and temperature segments. The omitted
switch can be restored or activated at any time by repeating the
steps described above. (ATTENTION! After reactivating a switch
that has been omitted before, inspect and correct, if required,
the device so that the times of switches are consecutive, in
accordance with the serial numbers of the switches!)
18