42
Opening the trailer
and erecting the t ent
• Opening the trailer tent should be
carried out on a fairly level site.
• Remember it is not recommendable
to place the trailer under trees.
Objects can fall down and eventually
damage or discolour the tent canvas.
• When the COMBI-CAMP is unhitched
and placed on the desired
spot, using the front support leg or
jockey wheel if fitted to level the
trailer tent.
• Wind down the rear jack legs until
trailer is level, it is recommended to
have a jack plate to avoid the leg
going into the ground, then unhook
the roof rack.
• Lift the roof rack over the trailer all
the way, which is approx.115
degrees from the top of the trailer.
(fig.2)
• Now open the top of the trailer
(Fig. 3), pull it towards and past the
position of the roof rack and further
until it reaches the ground.
Never use the roof rack as a lever.
Walk into the tent and push up the
two connecting
poles on the
centre trailer
frame until
the tent is
fully erected
and then tighten
the
thumbscrew.
• The tent canvas is now erected.
Adjust the internal frame adjusters
as shown below Adjust the front
support leg or jockey wheel if fitted
in order to level the tent floor so
that it is supported by the roof rack
which is now situated below the
floor. If required the two rear jack
legs can also be adjusted.
Fig. 1
Fig. 3
Fig. 2
