12
Before going to the USE section:
Check around area for flammables, especially
gasoline or other vapors which may ignite. The
exhaust and top of the unit will get HOT! Make sure
there are no foreign objects around the unit or have
fallen into the top.
Use and Starting
1. Turn on incoming water supply. Ensure that you have
adequate water pressure of between 20-80 PSI /1.38-
5.5 bar.
2. Turn your water output device to its “off” position.
3. Turn the gas valve on the cylinder all the way open.
4. IF THE SMELL OF GAS IS DETECTED, TURN OFF THE
GAS VALVE IMMEDIATELY!!!!
5. Set the water regulator knob on the face of the unit to
its highest setting.
6. Set the gas regulator knob on the face of the unit to
its minimum setting.
7. Turn on your water output device to the “on” position
and adjust to the desired water flow.
8. There will be a series of audible clicks and the burner
will ignite. (Should the burner not ignite after 5
seconds, shut off and go to the “Trouble Shooting”
section.