5
You can
customise
your remote
control to
use any 4
additional
TV-VCR-SAT-
DVD functions,
using the function keys F1- F2 - F3 - F4.
In the symbol table corresponding to your
remote control code, locate the additional
function you require and note down the
number which appears below it.
Note that only number functions can be saved
using F1- F2 - F3 - F4.
NOTE :
You cannot use the additional commands unless these were already available on your
original remote control.
PROGRAMMABLE KEYS
The function programming procedure is as
follows:
TV function example: EXP BOT
Press and hold down SHIFT and type in the
number written beneath function 028.
Press one of the function keys (e.g. F1) and
hold it down together with SHIFT.
After a few seconds, the TV-VCR-SAT-DVD
selection key for the appliance you have
chosen will emit a series of 3 flashes to
indicate that the function has been saved
correctly. Release SHIFT and F1.
From now on, whenever you press F1, the
additional command just saved is transmitted
to the appliance and stops when F1 is
released.
3. FOR THE LESSER-USED FUNCTIONS, refer to the code book appendix.
Find the symbol table corresponding to the code you saved to program the remote control.
Locate the additional function you require and note down the symbol or number which appears
below it. EXAMPLE: XXX CODE TABLE
NOTE :
If the TV - VCR - SAT - DVD selection key does not flash, repeat the saving procedure
described above.
C - TV function example: EXP BOT
A number appears beneath the function (028).
Press and hold down SHIFT.
Type in the number, holding down the last digit
(8). The function is transmitted to the appliance
and stops when you release the two keys
(SHIFT+ 8).
D - TV function example: contrast +
A symbol and a number are displayed beneath
the function.
You can apply the command using either the
symbol or the number.
Locate this symbol on your remote control and
press the key to transmit the function to the
appliance.
If you want to use the number, refer to example
C above.
There are 4 ways to enable the additional
commands:
A - TV function example: brightness (+)
A symbol appears beneath the function.
Locate this symbol on your remote control and
press the key to transmit the function to the
appliance. The command stops when you
release the key.
B - TV function example: FULL TOT
A symbol against a grey background appears
beneath the function.
Locate this symbol on your remote control.
Press SHIFT and the key at the same time. The
corresponding function is transmitted to the
appliance and stops when you release the
keys.
REV RIV
TUPO CANCEL
–+–+–+
TP OFF TP ON FULL EXP EXP ALTO
TIME ORA MEM F MEM TOT TOP BOT I-II
XXX *
MENU MENU
●
015 014 014
●
015 AV 027 028 027
MIX 10 11
030 058 059
Original remote control / TOPTEL
additional functions symbols or numbers
▼
▼
▼
▼
▼
▼
■❙❙
▼
▼
..
▼ ▼
▼ ▼
