3
Additional check
Check that some of the other
functions used on your original remote
control are working correctly.
If the commands function incorrectly
or erratically, you have probably
entered a code for a similar but
different remote control.
In this case, repeat the search
procedure from point 2.
1. Make sure that the TV is ON.
2. Hold down the SHIFT
and ON/OFF keys together
until the light indicator at the
top starts to flash indicating
that the remote control is in
programming mode.
3. Release the keys.
Within 15 seconds,
enter the code 000.
The light indicator flashes more
quickly to indicate that the remote
control is ready for the search.
4. Point the remote control at the TV.
Press and release slowly one of
the most frequently used keys
several times STOPPING when
the appliance responds correctly
to the command.
5. When the TV responds correctly,
press SHIFT to confirm.
Three flashes indicate that
the operation has been
completed correctly.
Identify and make a note of the TV
code which you have searched
for, following the code noting procedure
(see “NOTING THE PROGRAMMED
CODE” section).
NOTE: THE LIGHT INDICATOR
STOPS FLASHING.
The remote control leaves the
programming mode and the light
indicator stops flashing:
• if no keys are pressed for 15 seconds
• if the code search list is completed.
1. Make sure that the TV is ON.
2. In the code book enclosed,
look for the brand of your TV
and make a note of the first
code indicated BENEATH
the brand previously identified
(e.g. Philips 103).
3. Hold down the SHIFT
and ON/OFF keys together
until the light indicator at the top
starts to flash indicating that the
remote control is in programming
mode.
4. Release the keys.
Within 15 seconds, enter the
code previously identified
(e.g. 103). Three flashes indicate
that the code has been saved
correctly. If not, try the code entry
procedure again from point 3.
Additional check
Point the remote control at the TV.
Check that the appliance responds
correctly to the commands sent.
If there is no response or the appliance
only responds partially or incorrectly,
it is probable that you have used
the wrong code. In this case, try the
procedure again from point 3.
This time, however, use the
NEXT CODE in the list (e.g. 111).
Note down the TV code used to program
the remote control on the adhesive label
inside the battery cover for rapid
consultation.
NOTE: THE LIGHT INDICATOR
STOPS FLASHING
The remote control leaves the
programming mode and the light indicator
stops flashing:
• if no keys are pressed for 15 seconds
• if an invalid brand code is entered.
DIRECT CODE ENTRY
B
1
0
3
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
C
This operation may take up to about 20 minutes.
0
0
0
