4
NOTING THE PROGRAMMED CODE
To find the code for your remote control:
1.Press one of the TV or VCR selection
keys for the appliance whose code
you want to identify.
2. Hold down the SHIFT and ON/OFF
keys together until the TV or VCR
selection key starts to flash.
3. Release the SHIFT and ON/OFF keys
and then press and release the 1-/--
key.
4. After a few seconds, the TV or VCR
selection key you used,
communicates the code by flashing
the three numbers separately.
Count the number of flashes for each
code number. For example, for the
code 306, the key flashes three, zero
and six times to give:
= 3
= 0
= 6
5. Note this code on the label inside the
battery cover for rapid consultation.
USING THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
Although not indicated on the keypad, some keys can be used for additional commands.
1. Use your TOPTEL 2 Plus remote control to find them by pressing the following keys one by
one or together with the SHIFT key:
2. The most frequently used additional commands like MENU SCROLL – COLOUR –
BRIGHTNESS and NORMALISATION are located as follows:
normalisation
menu (up) menu (up) + brightness (-) red brightness (-) + red
menu (down) menu (down) + brightness (+) green brightness (+) + green
menu (right) menu (right) + color (-) yellow color (-) + yellow
menu (left) menu (left) + color (+) blue color (+) + blue
USING THE REMOTE CONTROL FOR 2 TVs
You can use the remote control for 2 TVs instead of 1 TV and 1 VCR.
VOLUME CONTROL AVAILABLE AT ALL TIMES
You can raise or lower the TV volume or use the mute function while
watching the VCR without having to press the TV selection key.
OK
VCR
TV
1-/--
Always write down the 3-digit code for your remote control on the label inside the
battery cover after running the search and saving the code. This may be useful if you
need to reprogram your remote control in the event of accidental cancellation or when
you change used batteries.
If you forget to write down the code or use the remote control programming
procedures A or C …. don’t worry!
4. Enter the two codes following
programming procedure B
from point 3.
Start by pressing the TV
selection key to enter the code
for the first TV and then the VCR
selection key to enter the
code for the 2
nd
TV.
1. Look for the code for the first TV,
following any of the programming
procedures A , B or C described
above.
2. Make a note of the three-digit code
identified.
3. Repeat the search for the second TV
and make a note of the code.
