554024
10
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
USER MANUAL
USER MANUAL
1.3 Requirements
The following are required to install and use the Clone+™ devices:
• digital satellite, cable or terrestrial receivers of Conax, Cryptoworks, MediaGuard,
Viaccess-coded pay-tv.
• a working installation* connected to each of the digital satellite, cable or terrestrial
receivers,
• valid subscriber card.
1.4 Other electronic equipment
Devices which emit radio transmission in their wireless communication may
disrupt the performance of the Clone+™ devices.
1.5 Important notes
Use only the designated power adapter and accessories approved by PYCH International
Electronics Sp. z o.o.. Using any other unsuitable power adapters and accessories which are
not approved by PYCH International Electronics Sp. z o.o. may result in damaging the unit
or severe injury.
* a working installation is herewith dened as an installation in which all the devices have been
installed properly.
1. Safety and usage information
The Clone+™ devices have been designed according to the safety standards. Before using
this unit, make sure to read the safety and usage information as well as the User Manual.
1.1 Small children and animals
The Clone+™ devices contain small parts which may cause choking or serious injuries if
swallowed. Keep this unit out of the reach of small children or animals.
1.2 Precautions
• Keep the Clone+™ device away from rain, moisture and humidity.
• Keep the Clone+™ device away from direct sunlight, heat-generating equipment or
strong magnetic eld or its emitters or generators.
• It is advised not to use the Clone+™ device during the storm. It is recommended
to unplug the device from the mains to eliminate the risk of the electrical shock or
short-circuit.
• Do not clean the Clone+™ device with water, liquids or aerosols.
• The voltage of the designated power adapter that comes with this unit is 230V AC/50-
60Hz.
• Do not overload wall power outlets or extension cords, as this may result in the risk of
re or electrical shock.
4 5
2. About Clone+™
2.1 How it works :
The Clone+™ SRF150 Access Server is a main unit which multiplies the privileges of the
subscriber card and sends them to the authorised wireless Clone+™ CRF150 Client Cards.
The Clone+™ CRF150 Client Cards are subordinate units which co-ordinate the
information exchange between the SmartCard reader module in the digital satellite, cable
or terrestrial receiver (or CI module) and the Clone+™ SRF150 Access Server.
2.2 Benets to the user:
• viewing the digital pay-tv simultaneously on 8 TV receivers (independent channels)
with paying only for one subscriber’s plan,
• cost saving solution for the user (one subscriber’s plan serves up to 8 TV receivers).
2.3 Key features:
• Dedicated for the digital tv platforms using the content encryption systems such as
Conax, CryptoWorks, MediaGuard, Viaccess,
• 8 active users,
• unauthorised access protection,
• works with all digital satellite, cable, terrestrial receivers and CI modules which are
Conax, CryptoWorks, MediaGuard, Viaccess compatible,
• an extended system of LED indicators,
• advanced Plug&Play technology,
•
• fast and reliable performance,
• software update via USB,
• easy and fast installation.
2.4 Product specication:
• transmission: RF 868 - 915MHz, BW 150kHz, GFSK, NRZ 38.4 Kbps,
• variable transmitter power from -20 to 5 dBm,
• range up to 150 meters (outdoors),
• DC 12V-powered.
3. Contents
Note:
The Clone+™ devices only send the subscriber card privileges and do not aect the
quality of the sound and vision whatsoever.
Wireless Access Server SRF150 1
Wireless Client Card CRF150 2
12V power adapter 1
User Manual 1
Mini CD 1
USB cable 1
6 7
4. First steps
4.1 Installation of the SRF150 Access Server and authorisation of the CRF150 Client
Cards.
Step-by-step procedure:
1. Insert the valid subscriber card of the service provider into the servers SmartCard slot.
2.
3. Connect the power tip to the Server SRF150 and then plug the power adapter into the
230V AC/50-60Hz mains socket.
1. Wait until the Ready LED is ON.
1. Remove the subscriber card from the servers SmartCard slot.
1. Insert the CRF150 Client Card into the server’s SmartCard slot.
1. Wait until the Upgrade LED is OFF on the CRF150 Client Card.
1. Remove the CRF150 Client Card from the server’s SmartCard slot - the Client Card is
now ready to use with digital receivers or CI modules.
2.
3. Insert the valid subscriber card of the service provider into the servers SmartCard slot.
4.
5. Insert the CRF150 Client Card into the digital receiver or CI module.
Note:
To authorise another CRF150 Client Card, repeat steps 5 to 7.
8 9
Insert the valid subscriber card of the service provider into the server’s
SmartCard slot.
Connect the power tip to the SRF150 Server and then plug the power adapter
into the 230V AC/50-60Hz mains socket.
SUBSCRIBER CARD
SUBSCRIBER CARD
10 11
Wait until the Ready LED is ON. Remove the subscriber card from the server’s SmartCard slot.
SUBSCRIBER CARD
SUBSCRIBER CARD
12 13
Insert the CRF150 Client Card into the server’s SmartCard slot. Wait until the Upgrade LED is OFF on the CRF150 Client Card.
14 15
Remove the CRF150 Client Card from the server’s SmartCard slot.
Insert the valid subscriber card of the service provider into the server’s
SmartCard slot.
SUBSCRIBER CARD
16 17
Step-by-step procedure:
Authorise the CRF150 Client Cards according to 4.1, steps 1 to 7 for rst
valid subscriber card of the service provider.
Authorise the CRF150 Client Cards according to 4.1, steps 1 to 7 for another
valid subscriber card of the service provider.
Insert valid subscriber cards of the service providers into the Twin Slot Interface’s
SmartCard slots.
Insert the Twin Slot Interface into the server’s SmartCard slot.
Insert the CRF150 Client Cards into the digital receivers or CI modules.
Insert valid subscriber cards of the service providers into the Twin Slot Interface’s
SmartCard slots.
Insert the Twin Slot Interface into the server’s SmartCard slot.
4.2 Installation of the SRF150 Access Server working with Twin Slot Interface
and authorisation of the CRF150 Client Cards.
Twin Slot Interface enables simultaneous work of subscriber cards of two
dierent service providers.
Insert the Twin Slot Interface as indicated
Card with
the chip this side
18 19
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Clone Plus CRF150 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Clone Plus CRF150 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Andere handleiding(en) van Clone Plus CRF150

Clone Plus CRF150 Gebruiksaanwijzing - Nederlands - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info