EN EN
Introduction
Dear Customer,
by buying the Cloer filter coffee maker you have
decided on a quality product complying with
the most modern development standard regar-
ding technology and functionality.
Make sure you acquaint yourself with the
appliance before and read the operating
instructions carefully.
We wish you pleasure with your new filter coffee
maker.
Setting up
Remove all packaging parts and, if applicable,
stickers, not the rating label.
Place the filter coffee maker on a dry, non-slip
and even surface.
CE marking
The appliance meets the require-
ments of the applicable EC direc-
tives.
Indoor use
The appliance is intended for in
door use only.
Before using the first time
Read these instructions carefully before first use.
Prior to brewing coffee for the first time, run
the coffee maker with water only for one or two
times (omitting coffee powder and filter insert).
Open the lid of the water tank and fill in cold
water to the MAX marking. The water tank is
removable and can be taken to the sink to be
filled. Alternatively you can also use glass carafe
to fill the tank to the MAX marking.
Place the carafe on the „Keep Warm“ plate and
press the ON/OFF button to switch on the ap-
pliance.
Switch off the coffee maker after the brewing
process and pour away the water.
Safety instructions for operation
Use the coffee maker exclusively for making
coffee. Do not fill other liquids or foodstuffs in
the coffee maker.
Do not immerse the coffee maker in water or
any other liquid!
ATTENTION: When filling the water reservoir
with water, avoid the MAX marking being
exceeded. A possible bubbling over can cause
a danger of scald.
Brewing coffee
Fill the reservoir with the desired amount of cold
water. You can use the removable water tank or
the glass carafe. In each case go according to
the markings on the water reservoir.
When filling the water reservoir with water,
avoid the MAX marking being exceeded.
Open the filter holder to the left by pulling the
handle on the right.
Place a filter bag # 1x4 into the filter holder and
add the desired amount of ground coffee.
After that place the glass carafe on the “Keep
Warm“ plate.
Plug cord into a standard electrical outlet.
Switch on the appliance.
When brewing is complete, the “Keep Warm“
plate will keep the coffee hot as long as the cof-
fee maker is switched on.
Switch off the appliance when you no longer
need it.
Decalcification
First pour approximately 6 cups of water and
approximately 150 ml of citric acid or vinegar
into the coffee maker and switch the machine on.
After decalcifying, rinse the machine by ope-
rating it 2 times with 6 cups of clear water and
switch off the appliance.
Note: Regular decalcification (every 3 - 4 weeks)
guarantees a constant coffee quality, keeps
power consumption low and extends durabi-
lity of your coffee maker. The degree of calci-
fication depends on the local water hardness.
No warranty claim in case of faulty function-
ing due to calcification!
·
·
·
·
·
·
·
·
Cleaning
Allow the unit to cool.
Before cleaning ensure that the ON/OFF switch is
in the “off“ position and the unit is unplugged.
Open the pivot filter with filter insert and
remove it to the top.
Clean the filter insert and the glass carafe in hot
soapy water, then rinsed and dried thoroughly.
The outer housing and the pivot filter can be
cleaned with a soft, damp cloth.
Problem / Cause / Solution
Problem Possible
cause
Solution
Appliance
has no
function
Appliance
is not
connected
Put plug
in power
socket
Water
bubbles
over
Too much
water filled
in
Fill in less
water
Machine is
louder than
earlier
Machine is
calcified
Decalcify
machine
Boiling
process
takes longer
than earlier
Machine is
calcified
Decalcify
machine
Environmentally friendly disposal
We use only environmentally friendly packaging
for the transport of our appliances. Please recy-
cle cardboard / paper and plastic packaging
appropriately.
CAUTION!
Electrical appliances should
not be disposed of with
the household trash.
Electrical appliances contain valuable raw ma-
terials. When an appliance is worn-out, please
take it to a recognised recycling facility. Please
consult the local authorities for information on
recycling appliances.
Customer service
In the event that your Cloer appliance becomes
defective, please contact your Cloer dealer or
Cloer customer service department.
Cloer electrical appliances comply with current
EC guidelines and safety regulations.
Conditions of warranty
Cloer grants you, the private end user, a li-
mited manufacturer’s warranty. Assuming
careful handling and compliance with the ope-
rating instructions and safety notices, we will be
obligated to replace the appliance at no cost,
insofar as there are defects in material or work-
manship. The repair will be eff ected by repairing
or replacing defective components. Any parts
replaced will become the property of Cloer. All
further claims of any type, especially claims for
indemnifi cation, are not valid.
This warranty does not aff ect any rights of the
customer with respect to the sale of goods in
accordance with the applicable national laws.
The warranty period is 2 years starting from the
date on which the product was fi rst purchased
by an end consumer. The warranty period will
not be extended or begin anew or in any other
way be aff ected by the subsequent sale, repair
or replacement of the product.
This warranty is passed on to you by your re-
tail dealer. In order to assert a warranty claim,
please contact your dealer directly.
If you have questions about your product,
please contact the Cloer importer in your coun-
try. The address and telephone number can be
found on our website at http://www.cloer.de
or you can send an e-mail to
service-uk@cloer.de
As proof of warranty entitlement you must sub-
mit the original sales receipt with the date of
sale and the dealer’s address. Without the sales
receipt, the repair will be carried out at your ex-
pense without asking.
98
