List of Parts
First Use of the Machine
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use, please pass the iron a few
times over an old clean cloth.
• Turn the seal (7) of the water tank and fill it through the filling aperture with not
more than 1,0 litre of pure water. Then re-tighten the seal.
Using the Machine
Ironing without Steam
1. The clothes to be ironed should be sorted out according to their ironing
temperature.
2. Please begin with the lowest temperature. This can be set on the temperature
regulator (1):
• (Synthetic materials, silk) low temperature
• • (Wool) medium temperature
• • • (Cotton, linen) high temperature
3. Place the machine on the iron well.
4. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Turn operating switch I (10) on the station to position I and move the steam
regulator (9) to MIN. Operating switch I (10) lights up. Please ensure that ope-
rating switch II (11) is turned to position 0.
5. The control lamp of the iron (5) shows it is being heated up. As soon as the
control lamp goes off the operating temperature has been reached. Now you
can start ironing.
6. Always remove the mains plug after using the machine.
Steam Ironing
For this a high temperature is needed.
1. Turn the temperature control (1) to position "• • •" (cotton, linen).
2. Move both operating switches (10/11) to position I. When the lamp in operating
switch IIII goes out there is enough steam for steam operation.
30
GB
1 Temperature control
2 Steam-jet button
3 Fixing device
4 Connecting tube
5 Control lamp
6 Water tank
7 Lock/
Filling aperture for the water tank
8 Iron well
9 Steam control
10 Operating switch I
11 Operating switch II
